TC-2100-21 Hirose Electric Co Ltd, TC-2100-21 Datasheet - Page 5

• Manufacturer Part Number: TC-2100-21
• Description: TOOL CONTACT EXTRACTION
• Manufacturer: Hirose Electric Co Ltd
• Type: Hand Toolsr

Specifications of TC-2100-21

• Tool Type: Extraction Tool
• For Use With: H3251CT - CONN CONTACT 18-24AWG CRIMP GOLDH3251TR - CONN CONTACT 18-24AWG CRIMP GOLDH3251 - CONN CONTACT 18-24AWG CRIMP GOLDH3250 - CONN CONTACT 14-16AWG CRIMP GOLD
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: *TC-2100-21; H9915

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
In case of extracting a contact from the housing in insertion
error or in circuit change, follow the steps as shown below.
1. Hold the Contact Extractor, placing the tip of the
2. When the tip of the Extractor comes into contact
Extractor on the tip of a contact, then insert it
between the contact and the housing, following to
the Fig. 1.
with a stepped part in the housing, the spring will
come off from the stepped part with a snap which
is felt. Then, extract the contact by pulling the wire.
Assembling Procedure
Procedure for Contact Extraction
Contact
Extrator
Spring
Fig. 1
Crimped
3. Above Fig. 1 and Fig. 2 show how to extract a con-
4. When the extracted contact is installed again in the
tact from socket housing. The same procedure can
be employed to extract a contact from pin housing.
housing, do not forget to raise up the contact
spring to the original position.
Fig. 2
(Pull the wire)
After assembling, please make
sure if the contact is installed
as shown in the left by pulling
the cable slightly.
04/2009
143