90754-3 Tyco Electronics, 90754-3 Datasheet

no-image

90754-3

Manufacturer Part Number
90754-3
Description
SEATING TOOL ASSY HM 95 PIN
Manufacturer
Tyco Electronics
Datasheet
1.90754-1.pdf (3 pages)

Specifications of 90754-3

Lead Free Status / RoHS Status
Not applicable / Not applicable
Seating Tools 90754–[ ] are used to seat Z–PACK
2mm HM Type B male connector assemblies with
ACTION PIN contacts to allow solderless pc board
installation. Each seating tool is specifically designed
for the number of positions in the connector. Refer to
Figure 1.
Read these instructions thoroughly before using the
seating tool.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
E
i
All numerical values in this instruction sheet are
in metric units [with U.S. customary units in
brackets]. Dimensions are in millimeters [and
inches]. Figures are not drawn to scale.
Figure 1
Each seating tool consist of an adapter and a blade.
During seating, the blade sits inside the connector
engaging the housing floor and contacts preventing
the contacts from pushing out of the housing. The
adapter presses on the top surface of the connector
when the applicator ram applies force to the seating
tool.
A fixture must be used to provide proper support for
the pc board and alignment of the seating tool to the
contacts and to protect the pc board and and
connector from damage. The pc board support fixture
must be designed for the specific needs according to
Instruction Sheet 408–6927.

90754-3 Summary of contents

Page 1

... Seating Tools 90754–[ ] are used to seat Z–PACK 2mm HM Type B male connector assemblies with ACTION PIN contacts to allow solderless pc board installation. Each seating tool is specifically designed for the number of positions in the connector. Refer to Figure 1. Read these instructions thoroughly before using the seating tool ...

Page 2

... Seating Tools 90754-[ ] 2.2. Application Tooling Power for seating tools must be provided by a machine capable of supplying a downward force of 133 Newtons (N) [30 lb] per contact. SM–3 Frame Assembly 814700–[ ] (Customer Manual 409–5626 provides instructions) can be used. 3. SEATING When setting up equipment to seat connectors, pay particular attention to the following: — ...

Page 3

... A complete inventory should be stocked and controlled to prevent lost time when replacement of G parts is necessary. Parts other than those listed should be replaced by Tyco Electronics to ensure quality and reliability. Order replacement parts through your representative, or call 1–800–526–5142, or send a facsimile of your purchase order to 717– ...