2-58511-0 Tyco Electronics, 2-58511-0 Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/6/687/tyco_electronics_sml.jpg)
2-58511-0
Manufacturer Part Number
2-58511-0
Description
SEATING TL 2MM FB 4-ROW
Manufacturer
Tyco Electronics
Datasheet
1.58511-3.pdf
(4 pages)
Specifications of 2-58511-0
Lead Free Status / RoHS Status
Not applicable / Not applicable
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper
support for the pc board and alignment of the tool to
the header pins, and to protect the pc board and
header posts from damage. Design a pc board
support fixture for your specific needs using the
recommendations in Instruction Sheet 408–6927.
3.2. Application Tooling
The pin headers can be seated with an application
unit capable of supplying a downward force of 102
Newtons (N) [23 lb] per contact. 10/20–Ton “H” Frame
Assembly 803880–6 is capable of seating up to 1740
contacts; SM–3 Frame Assembly 814700–[ ] seats up
to 261 contacts. For operating and setup procedure of
the frame assemblies, refer to Customer Manual
409–5567 (“H” frame assembly) or 409–5626 (SM–3
frame assembly).
4. SEATING
View After Seating
Seating Tools 58511-[ ]
1. Set seating height to the dimension shown in
Figure 3 (applicator shut height will equal the
seating height PLUS the combined thicknesses of
the pc board and pc board support).
2. Position header into pc board so that header
contacts are properly aligned to the board and
board support.
F
Figure 3
CAUTION
3. Insert header into pc board until the compliant
sections of the contacts are resting securely on,
but have not fully entered, the pc board.
4. Position appropriate seating tool into header,
making sure tool is bottomed on housing floor.
5. Center seating tool and header under the
applicator ram of the power source; slowly lower
ram until it just meets the seating tool. Verify the
alignment of the board support, pc board, header,
and seating tool.
6. Cycle applicator ram according to instructions
for the power source. Check assembly for proper
seating, using the requirements in Figure 3.
NOTE
7. Remove pc board and seated header, or
reposition board and board support for seating
additional headers.
!
i
Damage to the pc board, tool, or header may
occur if the wrong size tool is used, if seating
height is improperly set, or if tool is not
properly seated in the header before cycling the
applicator ram.
For additional information on inspection
requirements, refer to Application Specification
114-1075.
408-9910
3