B45196H2226M309 Kemet, B45196H2226M309 Datasheet - Page 19

• Manufacturer Part Number: B45196H2226M309
• Description: CAP TANTALUM 22UF 10V 20% SMD
• Manufacturer: Kemet
• Series: B45196Hr
• Type: Moldedr

Specifications of B45196H2226M309

• Capacitance: 22µF
• Voltage - Rated: 10V
• Tolerance: ±20%
• Esr (equivalent Series Resistance): 1.600 Ohm
• Operating Temperature: -55°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 2312 (6032 Metric)
• Size / Dimension: 0.236" L x 0.126" W (6.00mm x 3.20mm)
• Height: 0.098" (2.50mm)
• Manufacturer Size Code: C
• Features: General Purpose
• Voltage Rating: 10 Volts
• Operating Temperature Range: - 55 C to + 125 C
• Dissipation Factor Df: 6
• Leakage Current: 2.2 uAmps
• Product: Tantalum Solid High Temperature
• Termination Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Spacing: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 495-2211-2; T491C226M010ZT

Low-resistance applications and voltage networks
For low-resistance applications, KEMET recommends a maximum operating voltage of half the
permissible maximum continuous voltage, so that the capacitors have sufficient tolerance to
withstand voltage peaks. Depending on the conditions of use, the early failure rate is higher here
by a factor of 2 to 20 than in the range with a constant failure rate as specified in the data book.
When operated directly in a voltage network, the capacitor should be protected against
overvoltage, e.g. by a suppressor diode, and against polarity reversal by a diode. If a capacitor is
operated in an unprotected low-impedance circuit and fails because the permissible conditions for
the forward DC voltage, reverse DC voltage, surge current, power dissipation or temperature are
exceeded, the continued current flow through the overstressed capacitor may produce
overheating. The overheated capacitor may damage the surrounding components and the circuit
board.
Storage conditions
Capacitors with solid electrolyte may be stored at temperatures down to –80 C. The upper
storage temperature must not exceed +85 C (for blister tape the temperature limit is +40 C).
The storage conditions should not exceed +40 C and 70% R. H. A drypack is useful to prevent
the effects of humidity.
Please read Important notes and
Cautions and warnings at the end of this document.
Tantalum chip capacitors
Standard / HighCap
Page 19 of 20
B45196E, B45198E, B45196H, B45198H