B45196H1685K109 Kemet, B45196H1685K109 Datasheet - Page 19
![CAP TANTALUM 6.8UF 6.3V 10% SMD](/photos/1/7/10796/399-3216-18_sml.jpg)
B45196H1685K109
Manufacturer Part Number
B45196H1685K109
Description
CAP TANTALUM 6.8UF 6.3V 10% SMD
Manufacturer
Kemet
Series
B45196Hr
Type
Moldedr
Datasheet
1.B45196H2226M109V17.pdf
(20 pages)
Specifications of B45196H1685K109
Capacitance
6.8µF
Voltage - Rated
6.3V
Tolerance
±10%
Esr (equivalent Series Resistance)
4.500 Ohm
Operating Temperature
-55°C ~ 125°C
Mounting Type
Surface Mount
Package / Case
1206 (3216 Metric)
Size / Dimension
0.126" L x 0.063" W (3.20mm x 1.60mm)
Height
0.063" (1.60mm)
Manufacturer Size Code
A
Features
General Purpose
Voltage Rating
6.3 Volts
Operating Temperature Range
- 55 C to + 125 C
Dissipation Factor Df
6
Leakage Current
0.5 uAmp
Product
Tantalum Solid High Temperature
Termination Style
SMD/SMT
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Spacing
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
495-2178-2
T491A685K006ZT
T491A685K006ZT
Low-resistance applications and voltage networks
For low-resistance applications, KEMET recommends a maximum operating voltage of half the
permissible maximum continuous voltage, so that the capacitors have sufficient tolerance to
withstand voltage peaks. Depending on the conditions of use, the early failure rate is higher here
by a factor of 2 to 20 than in the range with a constant failure rate as specified in the data book.
When operated directly in a voltage network, the capacitor should be protected against
overvoltage, e.g. by a suppressor diode, and against polarity reversal by a diode. If a capacitor is
operated in an unprotected low-impedance circuit and fails because the permissible conditions for
the forward DC voltage, reverse DC voltage, surge current, power dissipation or temperature are
exceeded, the continued current flow through the overstressed capacitor may produce
overheating. The overheated capacitor may damage the surrounding components and the circuit
board.
Storage conditions
Capacitors with solid electrolyte may be stored at temperatures down to –80 C. The upper
storage temperature must not exceed +85 C (for blister tape the temperature limit is +40 C).
The storage conditions should not exceed +40 C and 70% R. H. A drypack is useful to prevent
the effects of humidity.
Please read Important notes and
Cautions and warnings at the end of this document.
Tantalum chip capacitors
Standard / HighCap
Page 19 of 20
B45196E, B45198E, B45196H, B45198H