EL5171 INTERSIL [Intersil Corporation], EL5171 Datasheet
EL5171
Available stocks
Related parts for EL5171
EL5171 Summary of contents
Page 1
... Generally, these pins are grounded but can be tied to any voltage reference. All outputs are short circuit protected to withstand temporary overload condition. The EL5171 and EL5371 are specified for operation over the full -40°C to +85°C temperature range. Ordering Information PART ...
Page 2
... T Electrical Specifications +5V Specified. PARAMETER DESCRIPTION AC PERFORMANCE BW -3dB Bandwidth BW ±0.1dB Bandwidth SR Slew Rate (EL5171) Slew Rate (EL5371) t Settling Time to 0.1% STL t Output Overdrive Recovery Time OVR GBWP Gain Bandwidth Product V BW (-3dB) V -3dB Bandwidth REF ...
Page 3
... LD CONDITIONS (EL5371) REF V = ±2. (EL5171 (EL5371 500Ω to GND (EL5171 500Ω to GND (EL5371 10Ω ±3.24 (EL5171 10Ω ±3.24 (EL5371 from ±4.5V to ±5.5V (EL5171 from ±4.5V to ±5.5V (EL5371) ...
Page 4
... EL5171, EL5371 PIN NAME INN1, INN2, INN3 Inverting inputs, note that on EL5171, this pin is also the REF pin FBN3, FBN2, FBN1 Feedback from inverting output OUT3B, OUT2B, OUT1B Inverting outputs VSP Positive supply VSN Negative supply ...
Page 5
... R F1 -5V 1 FBP OUT 8 2 INP VSN REF VSP FBN OUTB 5 50Ω 50Ω +5V FIGURE 1. EL5171 + OUT1 28 2 INP1 FBP1 INN1 FBN1 26 4 REF1 OUT1B VSP 24 INP2 VSN INN2 OUT2 ...
Page 6
... R = 1kΩ 2.7pF 200Ω 10M FREQUENCY (Hz) FIGURE 7. FREQUENCY RESPONSE 6 EL5171, EL5371 V = 200mV OP P-P 100M 1G FIGURE 4. FREQUENCY RESPONSE FOR VARIOUS GAIN = 1kΩ 500Ω LD 100M 1kΩ 500Ω F 100M 400M R = 1kΩ ...
Page 7
... FREQUENCY (Hz) FIGURE 11. PSRR vs FREQUENCY 1k 100 100 1k 10k 100k FREQUENCY (Hz) FIGURE 13. VOLTAGE AND CURRENT NOISE vs FREQUENCY 7 EL5171, EL5371 (Continued) 100M REF 100M 10M 10M 100 10 1 0.1 10k 100k 1M 10M FREQUENCY (Hz) FIGURE 10. OUTPUT IMPEDANCE vs FREQUENCY 100 90 ...
Page 8
... S LD OP- for OP- -40 HD3 (A -50 -60 -70 -80 -90 -100 FREQUENCY (MHz) FIGURE 19. HARMONIC DISTORTION vs FREQUENCY 8 EL5171, EL5371 (Continued) 4.0 4.5 5.0 FIGURE 16. HARMONIC DISTORTION vs DIFFERENTIAL 700 800 900 1000 50mV/DIV FIGURE 20. SMALL SIGNAL TRANSIENT RESPONSE V = ±5V 1kΩ ...
Page 9
... Typical Performance Curves 0.5V/DIV 10ns/DIV FIGURE 21. LARGE SIGNAL TRANSIENT RESPONSE M = 200ns, CH1 = 500mV/DIV, CH2 = 5V/DIV CH1 CH2 200ns/DIV FIGURE 23. DISABLED RESPONSE FIGURE 25. PACKAGE POWER DISSIPATION vs AMBIENT TEMPERATURE 9 EL5171, EL5371 (Continued) CH1 CH2 1.2 1.0 0.8 0.6 0.4 0.2 FIGURE 24. PACKAGE POWER DISSIPATION vs AMBIENT JEDEC JESD51-7 HIGH EFFECTIVE THERMAL CONDUCTIVITY TEST BOARD 1 ...
Page 10
... REF pin is from -3.3V to 3.8V. If the input common mode or differential mode signal is outside the above-specified ranges, it will cause the output signal to become distorted. The output of the EL5171 and EL5371 can swing from -3.9V to +3.9V at 1kΩ differential load at ±5V supply. As the load resistance becomes lower, the output swing is reduced. ...
Page 11
... R can help to reduce the ringing and peaking at F the expense of reducing the bandwidth. The bandwidth of the EL5171 and EL5371 depends on the load and the feedback network. R and R F with the load for gains other than +1. As this combination gets smaller, the bandwidth falls off ...
Page 12
... EL5171, EL5371 to GND will suffice. This same capacitor combination should be placed at each supply pin to ground if split supplies are to be used. In this case, the V supply rail. For good AC performance, parasitic capacitance should be kept to a minimum. Use of wire wound resistors should be avoided because of their additional series inductance ...
Page 13
... Plastic or metal protrusions of 0.006” maximum per side are not included. 2. Plastic interlead protrusions of 0.010” maximum per side are not included. 3. Dimensions “D” and “E1” are measured at Datum Plane “H”. 4. Dimensioning and tolerancing per ASME Y14.5M-1994 13 EL5171, EL5371 D (N/2)+1 (N/2) H ...
Page 14
... However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries. For information regarding Intersil Corporation and its products, see www.intersil.com 14 EL5171, EL5371 MDP0040 QUARTER SIZE OUTLINE PLASTIC PACKAGES FAMILY (N/2)+1 ...