LTC1483 Linear Technology, LTC1483 Datasheet
LTC1483
Available stocks
Related parts for LTC1483
LTC1483 Summary of contents
Page 1
... I/O pins are protected against multiple ESD strikes of over 10kV. The LTC1483 is fully specified over the commercial and extended industrial temperature range and is available in 8-pin DIP and SO packages. , LTC and LT are registered trademarks of Linear Technology Corporation. ...
Page 2
... Control Input Voltage ..................... – 0. Driver Input Voltage ....................... – 0. Driver Output Voltage ........................................... 14V Receiver Input Voltage .......................................... 14V Receiver Output Voltage ................ – 0. Operating Temperature Range LTC1483C........................................ LTC1483I .................................... – Lead Temperature (Soldering, 10 sec)................. 300 C ELECTRICAL C HARA TERISTICS C SYMBOL PARAMETER ...
Page 3
... Note 3: All typicals are given for V Receiver t – PLH PHL Temperature 100 125 –50 – TEMPERATURE ( C) 1483 G02 LTC1483 LTC1483 MIN TYP MAX UNITS 150 1200 ns 150 1200 ns 100 600 ns 150 1200 ns 100 1500 ns 100 1500 ns 150 1500 ns ...
Page 4
... A (Pin 6): Driver Output/Receiver Input. B (Pin 7): Driver Output/Receiver Input. V (Pin 8): Positive Supply. 4.75V < LTC1483 Receiving INPUTS *Shutdown mode for LTC1483 Driver Output High Voltage vs Output Current –10 –20 –30 –40 –50 –60 –70 –80 – ...
Page 5
... Figure 6. Driver Enable and Disable Times LTC1483 S1 TEST POINT LTC1483 • F02 Figure 2. Receiver Timing Test Load S1 500 OUTPUT LTC1483 • F04 Figure 4. Driver Timing Test Load 1.5V 1 PHL t SKEW 90% 10% LTC1483 • F05 0.5V 0. LTC1483 • F06 ...
Page 6
... ESD protection. Figure 9 shows the LTC1483 output stage while Figure 10 shows a conven- tional CMOS output stage. When the conventional CMOS output stage of Figure 10 enters a high impedance state, both the P-channel (P1) and the N-channel (N1) are turned off ...
Page 7
... Slew Rate The LTC1483 is designed for systems that are sensitive to electromagnetic radiation. The part features a slew rate limited driver that reduces high frequency electromag- netic emissions, while improving signal fidelity by reduc- ing reflections due to misterminated cables ...
Page 8
... TELEX W U than 50ns the part will not enter shutdown mode. Toggling either will wake the LTC1483 back up within 3 the slow slew rate driver was active immediately prior to shutdown, the supply current will not drop until the driver outputs have reached a steady state; this can take as long as 2 ...