HR30-6P-6P(71) Hirose Electric Co Ltd, HR30-6P-6P(71) Datasheet - Page 10

• Manufacturer Part Number: HR30-6P-6P(71)
• Description: CONN PLUG 6POS MALE SOLDER
• Manufacturer: Hirose Electric Co Ltd
• Series: HR30r

Specifications of HR30-6P-6P(71)

• Connector Type: Plug, Male Pins
• Number Of Positions: 6
• Shell Size - Insert: 6
• Mounting Type: Free Hanging (In-Line)
• Termination: Solder Cup
• Fastening Type: Push-Pull
• Orientation: Keyed
• Ingress Protection: IP67 - Dust Tight, Waterproof
• Shell Material, Finish: Polyphenylene Sulfide
• Features: Strain Relief
• Product Type: Connectors
• Contact Style: Pin (Male)
• Shell Style: Plug
• Number Of Contacts: 6
• Shell Size: 6
• Mounting Style: Cable
• Termination Style: Solder
• Shell Plating: Gold
• Contact Plating: Gold
• Cable Diameter: 4.2 mm to 5 mm
• Current Rating: 2 A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shell Size, Military: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: *HR30-6P-6P(71); HR580

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
10
BAssembly Procedures
1
2
Thread the back shell, strain relief, seal bushing, spring and push/pull locking collar over the cable as shown above.
Solder type
1. Pre-solder the exposed cable conductors (dia. A). The diameter of the pre-soldered conductors should not exceed 0.7
2. Insert the insulator body over the applicable solder termination fixture.
3. Insert the pre-soldered conductors in the contact soldering pot and solder them in place.
Crimp type
1. Crimp the applicable contact to the stripped conductor. Use correct crimp tools. Verify the dimensions and crimp
2. Insert the contact into the appropriate opening in the insulator body.
3. Verify fully seated position by applying a slight pull force on the conductor. The contact should remain in place.
mm for 6 contact plug and 1.0 mm for 3 contact plug.
Soldering iron temperature should be
configuration.
Re-insert if not seated.
Plug Assembly Sequence
applied for 3-4 second.
Solder type : 3 and 6 pos.
Solder type : 12 pos.
Crimp type : 10 and 12 pos.
2
2 mm
2 mm
-0
-0.5
A
mm
5.5 mm max.
15
10 mm max.
B
20 mm