JBXFE2G12MSSDSR Souriau Connection Technology, JBXFE2G12MSSDSR Datasheet - Page 37

• Manufacturer Part Number: JBXFE2G12MSSDSR
• Description: CONN PLUG 12POS SEAL IP67 SOLDER
• Manufacturer: Souriau Connection Technology
• Series: JBXr

Specifications of JBXFE2G12MSSDSR

• Connector Type: Plug, Male Pins
• Number Of Positions: 12
• Shell Size - Insert: 2
• Mounting Type: Free Hanging (In-Line)
• Termination: Solder
• Fastening Type: Push-Pull
• Orientation: G
• Ingress Protection: IP67 - Dust Tight, Waterproof
• Shell Material, Finish: Brass, Chrome over Nickel
• Features: Cable Clamp, Shielded
• Product Type: Connectors
• Shell Style: Plug
• Number Of Contacts: 12
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Shell Size, Military: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SOU1617

Wiring and assembly
instructions :
STRAIGHT PLUG
• Cable stripping :
• Connector preparation
• Contacts wiring : crimp contacts
• Contacts wiring : solder contacts
• Connector assembly
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Insert wire into solder cup and solder
see page 37
JKX Series
2 - Insert the contact into the insulator until the clip is fully seated and cannot be removed.
38
Removable solder contacts from 0.9 mm to 1.3 mm
1 - Insert wire into solder cup and solder
1 - Select the proper collet
2 - Slide protective boot
1 - Select the proper crimping tool (see page 48)
2 - Adjust the crimping tool based on the wire
3 - Crimp the contacts
1 - In case of shielded cable, comb out the shield
2 - Position 2 half bushes
3 - Position the taper seat
4 - Position all the sub-assembly in connector
5 - Screw the outershell
6 - Install the protective boot
and fold back over the tapper seat
insert key appears through the windows of one
bush.
housing
assembly well aligned.
values on page 39. Install the cable seal
the collet
the backnut
well positionned on the flats A and B. Place a
wrench to grip flats B, use the other wrench to
tighten the backnut at the flats A following the
torque values on page 39.
seal
collet
and the taper seat
of cable (see pg. 16)
size “AWG”. (See wire size and crimp tool
settings on the back of this locator.)
into the insulator until the clip is fully seated
and cannot be removed.
(see page 39).
, the cable seal
, making sure to keep the sub-
into the outershell
till bottoming. Use 2 wrenches
onto the cable. Strip end
then insert the contact
, making sure that the
, the backnut
on the half bushes
following the torque
, the outershell
if applicable.
and the cable
then screw
.
, the
and
.