STR730FZ1T6 STMicroelectronics, STR730FZ1T6 Datasheet - Page 21

• Manufacturer Part Number: STR730FZ1T6
• Description: MCU 32BIT 128K FLASH 144-TQFP
• Manufacturer: STMicroelectronics
• Series: STR7r

Specifications of STR730FZ1T6

• Core Processor: ARM7
• Core Size: 32-Bit
• Speed: 36MHz
• Connectivity: CAN, I²C, SPI, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 112
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-TQFP, 144-VQFP
• For Use With: MCBSTR730 - BOARD EVAL STM STR730 SERIES497-5509 - EVAL BOARD FOR ARMIC30 CAN CTRLR497-5047 - KIT STARTER IAR FOR STR730 MCU
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

STR73xFxx
4
4.1
4.1.1
4.1.2
4.1.3
4.1.4
4.1.5
Electrical parameters
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
given only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 6.
L
=50pF
Pin loading conditions
STR7 PIN
Figure 7.
A
=25° C and T
A
SS
=25° C and V
.
Pin input voltage
.
V
IN
A
Electrical parameters
=T
Figure
DD
Amax
=5 V. They are
STR7 PIN
Figure
7.
(given by the
6.
21/52