STM809LWX6F STMicroelectronics, STM809LWX6F Datasheet - Page 8

• Manufacturer Part Number: STM809LWX6F
• Description: IC MPU RESET CIRC 4.63V SOT23
• Manufacturer: STMicroelectronics
• Type: Simple Reset/Power-On Resetr

Specifications of STM809LWX6F

• Number Of Voltages Monitored: 1
• Output: Push-Pull, Totem Pole
• Reset: Active Low
• Reset Timeout: 140 ms Minimum
• Voltage - Threshold: 4.63V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-3
• Monitored Voltage: 3 V or 3.3 V or 5 V
• Undervoltage Threshold: 4.56 V
• Overvoltage Threshold: 4.7 V
• Manual Reset: No
• Watchdog: No
• Battery Backup Switching: No
• Power-up Reset Delay (typ): 280 ms
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1 V
• Supply Current (typ): 15 uA
• Maximum Power Dissipation: 320 mW
• Mounting Style: SMD/SMT
• Maximum Operating Temperature: + 85 C
• Chip Enable Signals: No
• Minimum Operating Temperature: - 40 C
• Operating Temperature Range: - 40 C to + 85 C
• Output Type: Active Low or Push-Pull
• Power Fail Detection: No
• Input Voltage: 7V
• Power Dissipation Pd: 320mW
• Supply Voltage Range: 1V To 5.5V
• No. Of Pins: 3
• Termination Type: SMD
• Ic Generic Number: 809
• Rohs Compliant: Yes
• Number Of Elements: 1
• Monitored Voltage 1 (typ): 3/3.3/5V
• Threshold Voltage 1 (max): 4.7V
• Watchdog Timer: No
• Reset Active Time: 280ms
• Package Type: SOT-23
• Operating Supply Voltage (min): 1V
• Operating Supply Voltage (max): 5.5V
• Reset Threshold Voltage (max): 4.7V
• Reset Threshold Voltage (min): 4.56V
• Family Name: STM809
• Power Dissipation: 320mW
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 3
• Supply Current: 0.015mA
• Filter Terminals: SMD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-3378-2

Operation
2.4
Note:
8/21
Valid RST output down to V
When V
becomes an open circuit. In most systems this is not a problem, as most MCUs do not
operate below 1 V. However, in applications where RST output must be valid down to 0 V, a
pull-down resistor may be added to hold the RST output low. This resistor must be large
enough to not load the RST output, and still be small enough to pull the output to ground. A
100 kΩ resistor is recommended.
The same situation applies for the active-high RST of the STM810/812. A 100 k
resistor to V
CC
falls below 1 V, the RST (STM809/811) output no longer sinks current, but
CC
should be used if RST must remain valid for V
Doc ID 9873 Rev 5
CC
= 0 V
CC
< 1.0 V.
STM809/810/811/812
Ω
pull-up