LT1962EMS8-5 Linear Technology, LT1962EMS8-5 Datasheet
LT1962EMS8-5
Specifications of LT1962EMS8-5
Available stocks
Related parts for LT1962EMS8-5
LT1962EMS8-5 Summary of contents
Page 1
... The parts come in fixed output voltages of 1.5V, 1.8V, 2.5V, 3V, 3.3V and 5V, and as an adjustable device with a 1.22V reference voltage. The LT1962 regu- lators are available in the 8-lead MSOP package. , LTC and LT are registered trademarks of Linear Technology Corporation. 400 350 300 3 ...
Page 2
... V = 2.8V 1mA to 300mA IN LOAD U W ORDER PART NUMBER LT1962EMS8 LT1962EMS8-1 LT1962EMS8-1.8 5 SHDN LT1962EMS8-2.5 LT1962EMS8-3 LT1962EMS8-3.3 LT1962EMS8-5 = 125 MS8 PART MARKING LTML LTPQ LTSZ LTPS LTTA LTPR LTPT = 25 C. (Note 3) A MIN TYP MAX UNITS 1.8 2.3 1.485 1.500 1.515 1.462 1.500 1 ...
Page 3
ELECTRICAL CHARACTERISTICS The denotes specifications which apply over the full operating temperature range, otherwise specifications are T PARAMETER CONDITIONS Load Regulation LT1962-2.5 LT1962-3 LT1962-3.3 LT1962-5 LT1962 (Note 4) Dropout Voltage I = 10mA LOAD 10mA ...
Page 4
LT1962 Series ELECTRICAL CHARACTERISTICS Note 5: Operating conditions are limited by maximum junction temperature. The regulated output voltage specification will not apply for all possible combinations of input voltage and output current. When operating at maximum input voltage, the output ...
Page 5
W U TYPICAL PERFOR A CE CHARACTERISTICS LT1962-2.5 Output Voltage 2. 1mA L 2.53 2.52 2.51 2.50 2.49 2.48 2.47 2.46 – 50 – 100 125 TEMPERATURE ( C) 1962 G07 LT1962-5 Output ...
Page 6
LT1962 Series W U TYPICAL PERFOR A CE CHARACTERISTICS LT1962-3.3 Quiescent Current 800 700 L 600 500 400 300 200 SHDN 100 SHDN ...
Page 7
W U TYPICAL PERFOR A CE CHARACTERISTICS LT1962 GND Pin Current 1500 SHDN 1250 *FOR V = 1.22V OUT 50mA* 1000 L 750 500 R ...
Page 8
LT1962 Series W U TYPICAL PERFOR A CE CHARACTERISTICS SHDN Pin Threshold (On-to-Off) 1 1mA L 0.9 0.8 0.7 0.6 0.5 0.4 0.3 0.2 0 125 –50 – 100 TEMPERATURE ( C) 1962 ...
Page 9
W U TYPICAL PERFOR A CE CHARACTERISTICS Input Ripple Rejection 300mA OUT(NOMINAL) + 50mV RIPPLE RMS BYP OUT 40 30 ...
Page 10
LT1962 Series W U TYPICAL PERFOR A CE CHARACTERISTICS LT1962-5 10Hz to 100kHz Output Noise ( BYP V OUT 100 V/DIV 1ms/DIV OUT 1962 G52 I = 300mA L LT1962-5 10Hz to 100kHz Output ...
Page 11
CTIO OUT LT1962 SHDN SENSE V IN GND 4 Figure 1. Kelvin Sense Connection pin. The ADJ pin voltage is 1.22V referenced to ground and the output voltage ...
Page 12
LT1962 Series U U APPLICATIO S I FOR ATIO IN OUT V LT1962 R2 IN ADJ R1 GND OUT ADJ ...
Page 13
U U APPLICATIO S I FOR ATIO temperature and applied voltage. The most common dielectrics used are Z5U, Y5V, X5R and X7R. The Z5U and Y5V dielectrics are good for providing high capacitance in a small package, but exhibit strong ...
Page 14
LT1962 Series U U APPLICATIO S I FOR ATIO For surface mount devices, heat sinking is accomplished by using the heat spreading capabilities of the PC board and its copper traces. Copper board stiffeners and plated through-holes can also be ...
Page 15
... INTERLEAD FLASH OR PROTRUSIONS SHALL NOT EXCEED 0.006" (0.152mm) PER SIDE Information furnished by Linear Technology Corporation is believed to be accurate and reliable. However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen- tation that the interconnection of its circuits as described herein will not infringe on existing patent rights. ...
Page 16
... Fast Transient Response Low Dropout Regulator LT1772 Constant Frequency Current Mode Step-Down DC/DC Controller LT1963 1.5A, Fast Transient Response Low Dropout Regulator Burst Mode is a trademark of Linear Technology Corporation. Linear Technology Corporation 16 1630 McCarthy Blvd., Milpitas, CA 95035-7417 (408) 432-1900 FAX: (408) 434-0507 www.linear-tech.com ...