ZU-1890M Panasonic - ATG, ZU-1890M Datasheet - Page 8

• Manufacturer Part Number: ZU-1890M
• Description: CARD READER FULL INSERT 2 TRACK
• Manufacturer: Panasonic - ATG

Specifications of ZU-1890M

• Card Reader Type: Magnetic, Push/Pull
• Interface: TTL
• Card Read/write Type And Tracks: Magnetic - Read Tracks 1,2
• Card Reading Direction: Ejection
• Card Standard: ISO 7810, ISO 7811
• Card Speed: 10 ~ 150 mm/s
• Supply Voltage: 4.5 V ~ 5.5 V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: PCR111; ZU1890M

9. UNIT LIFE AND RELIABILITY
10. GUARANTEE
11. MAINTENANCE
12. CAUTIONS ON THE USE
9.1 Life Magnetic head
9.2 Error rate
12.1 At the installation
(conditions) This error rate is obtained when a new normal card (data "1010"･･･ ) is horizontally
If defects should occur within one year after the delivery of the cardreader due to improper material or
bad workmanship, the defective parts shall be replaced or repaired, free of charge.
Because of difficulty at changing components on the P.C Board, replace of whole unit is
recommended for service and maintenance.
other than the indicated specification range.
(conditions) In a clean office room.
Please be noted that we do not guarantee proper performance of the card reader if it is used
(1) Be sure to install on a flat surface so as to prevent any force to be applied to the card
(2) In the case that it is to incorporate into a machine, be sure not to touch any part of machine
(3) Install it so as to run the card vertically to achieve most stable operation.
(4) Installation of a card guide plate at the both (front and back) sides of the card running part may
(5) Do not touch the P.C.B. with bear hands.
(6) Do not drop or bump anything against a card reader. Otherwise, failure may be the result.
(7) The card reader should avoid installation of the following environment.
・ Watery, humid or dusty place.
・ Near machines which generate magnetic field or inducted noise.
・ Place which gets direct sunlight.
reader at the installation.
Especially, electric noise on this area should be avoided not cause reading error.
structures to the flexible P.C.B. other than the mounting surface.
reinforce stability.
(Printer, LED display, CRT etc.)
passed at the standard speed (30 cm/s∼60 cm/s) by manual operation in the clean
environment at delivery from our company.
In damp or dirty atmosphere, the life may be 1/3 to 1/5 of the above figure.
: 300,000 times pass
: Less than 0.1%
- 6 -