GLK24064-25-FGW-VPT Matrix Orbital, GLK24064-25-FGW-VPT Datasheet - Page 10

• Manufacturer Part Number: GLK24064-25-FGW-VPT
• Description: LCD GRAPHIC DISPL 240X64 WHT BLU
• Manufacturer: Matrix Orbital
• Series: GLK24064-25r

Specifications of GLK24064-25-FGW-VPT

• Display Type: LCD - Color
• Display Mode: Transmissive
• Viewing Area: 132.00mm L x 39.00mm W
• Backlight: LED - White
• Dot Size: 0.49mm W x 0.49mm H
• Dot Pitch: 0.53mm x 0.53mm
• Dot Pixels: 240 x 64
• Interface: I²C, RS232, TTL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: GLK24064-25-GW-VPT; GLK24064-25-GW-VPT

2. Make the connections.
3. Create.
I
A more advanced connection to the GLK24064-25/GLT24064 is provided by the I
is best accomplished using a breadboard and the Breadboard Cable. Power must be supplied from your
breadboard or another external source. To dive right into your application and use the GLK24064-
25/GLT24064 in I
1. Set the Protocol Select switches.
2. Make the connections.
3. Create.
2
C Connections
a.
b.
c.


a.
b.

MOGD# or hyperterminal will serve to get you started, and then you can move on with your
own development. Instructions for these programs can be found below and a variety of
application notes are available at
I
others are open.
This time you're on your own. While there are many examples within the Matrix Orbital
AppNote section, www.matrixorbital.ca/appnotes, too many controllers and languages exist to
cover them all. If you get stuck in development, it is possible to switch over to another protocol
on the standard board, and fellow developers are always on our forums for additional support.
2
Connect the six pin female header of the Extended Communication/Power Cable to the
Communication/Power Header of your GLK24064-25/GLT24064.
Insert the male end of your serial cable to the corresponding DB9 header of the Extended
Communication/Power Cable and the mate the female connector with the desired
communication port of your computer.
Select an unmodified floppy cable from a PC power supply and connect it to the power header
of the Extended Communication/Power Cable.
Connect the Breadboard Cable to the Communication/Power Header on your GLK24064-
25/GLT24064 and plug the four leads into your breadboard. The red lead will require power,
while the black should be connected to ground, and the green and yellow should be connected
to your controller clock and data lines respectively.
Pull up the clock and data lines to five volts using a resistance between one and ten kilohms on
your breadboard.
C: Ensure that the two I
2
C mode, get started with the guidelines below.
2
C jumpers in the corresponding protocol box are connected while all
www.matrixorbital.ca/appnotes.
2
C protocol setting. This
4