STEVAL-IHM029V1 STMicroelectronics, STEVAL-IHM029V1 Datasheet - Page 48

• Manufacturer Part Number: STEVAL-IHM029V1
• Description: BOARD DEMO MOTOR CTRL VIPER16L
• Manufacturer: STMicroelectronics
• Series: VIPer™ plusr
• Type: Other Power Managementr

Specifications of STEVAL-IHM029V1

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: STM8S103F2, T1235H
• Primary Attributes: Universal Motor Control, 90 ~ 265 VAC Input, 2000 W Output
• Secondary Attributes: LED Status Indicators
• Operating Supply Voltage: 90 V to 265 V
• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM8S103F2
• Other names: 497-10752

Electrical characteristics
10
10.1
10.1.1
10.1.2
10.1.3
10.1.4
48/113
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on characterization,
the minimum and maximum values refer to sample tests and represent the mean value plus
or minus three times the standard deviation (mean ± 3 Σ).
Typical values
Unless otherwise specified, typical data are based on T
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are not
tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in the following figure.
Figure 7: Pin loading conditions
DocID15441 Rev 6
50 pF
STM8S103K3 STM8S103F3 STM8S103F2
STM8 PIN
A
A
SS
= 25 °C and T
= 25 °C, V
.
DD
= 5 V. They are given
A
= T
Amax
(given by