ACC-CONSMAM3120-E Sigma Designs Inc, ACC-CONSMAM3120-E Datasheet - Page 11

• Manufacturer Part Number: ACC-CONSMAM3120-E
• Description: MOD Z-WAVE PCB WHIP EU 3120C-EW
• Manufacturer: Sigma Designs Inc
• Series: Z-WAVEr
• Type: Transceiver, Z-Waver

Specifications of ACC-CONSMAM3120-E

• Frequency: 868.42MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 370100810; 703-1027

INS10027-6
Zensys A/S
P[0.1-0.0],
RESET_N
Please note that the SPI interface (MISO, MOSI, SCK and SS_N) is not available for the Application SW
in some Z-Wave protocol API’s, see [1].
P[1.7-1.0]
ADC[3:0]
INT[1:0]
ZEROX
SS_N
TRIAC
MISO
MOSI
Name
P1.5 /
PWM
SCK
+3.3V
GND
RXD
TXD
VPP
1
1
1
1
Program
supply
Power
Power
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I
I
Table 3 Application Connector Signal Description
TRIAC Control: A triac controller is implemented in the
ZW0201 Single Chip that can controls a triac on the
Application Module like light dimmer modules etc.
Description
Module 3.3V supply input.
Analog-to-Digital Converter input. The ADC is 12/8 bit and
can use VCC, an internal or an external voltage as
reference.
ADC3: input
ADC2: input
ADC1: input/lower reference
ADC0: input/higher reference
Ground signal
Interrupt: The signal can be either level or edge trigged.
When in power down mode, the ZM2102 Z-Wave Module’s
MCU can be woken up by asserting the interrupt signal.
In/Out: General purpose I/O signal.
Master-In-Slave-Out SPI interface: output in slave mode
operation and input in master mode operation.
Master Out Slave In SPI interface: input in slave mode
operation and output in master mode operation.
Pulse Width Modulator Output: Used for frequency variation
applications.
Reset: Active low reset. The ZW0201 Single Chip has an
integrated Power-On-Reset and Brown-out detection
circuitry.
UART Receive Data: Supports 9.6kbaud, 37.4kbaud,
115.2kbaud.
SPI Clock: Can be used as either master SPI clock output or
slave SPI clock input.
Slave Select: Active low SPI slave select input. When in SPI
slave mode the input acts as chip select input.
UART Transmit Data: Supports 9.6kbaud, 37.4kbaud,
115.2kbaud.
Reserved for programming of future modules.
Not connected when used together with ZM2102 or
ZM3102N.
Zero Cross Detection: Zero cross detection signal used on
dimmer modules detecting 120/240V zero crossing.
Z-Wave Module Selection Guideline
Z-Wave Modules
Page 8 of 14
2007-03-16