AC164106 Microchip Technology, AC164106 Datasheet - Page 34

• Manufacturer Part Number: AC164106
• Description: MODULE RCVR RFPIC 433MHZ (PKG/5)
• Manufacturer: Microchip Technology
• Type: Receiverr

Specifications of AC164106

• Frequency: 433MHz
• Wireless Frequency: 315 MHz
• Modulation: ASK
• For Use With/related Products: PICkit™ 1
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

MPLAB
RS-232 and Power Supply Kit
Universal Power Supply and Serial Cable to support
using the ICD 2 for serial communications or with the
Universal Programmer Module. These items are
included with the MPLAB
(DV164006) and MPLAB
(DV164007) products.
Universal Programming Module
(MPLAB ICD 2) to provide an easy means for
programming microcontrollers.
Seven flying leads break out the primary programming
lines needed for any microcontroller. These are
connected to the 40 breakout pins of the ZIF socket,
allowing any part to be configured to the necessary
programming lines.
Features
DS30177S-page 32
Ordering Information:
AC162048
AC162049
AC162050
AC162051
AC162052
AC162053
AC162054
AC162055
AC162056
AC162057
• ZIF Socket
• Supports up to 40-pin devices from 300 to 600 mil
• MPLAB ICD 2 Connector
Development Systems Ordering Guide
width
®
RS-232 and Power Supply Kit
Universal Programming Module
PIC12F629/675 MPLAB ICD 2 Header Interface Module
MPLAB
PIC16F630/676 MPLAB ICD 2 Header Interface Module (14-pin DIP)
PIC16F648A/627A/628A MPLAB ICD 2 Header Interface Module (18-pin DIP)
MPLAB
MPLAB
MPLAB
MPLAB
ICD 2 Accessories
®
®
®
®
®
®
®
ICD Header Interface Module
ICD 2 18-pin Header (PIC16F716)
ICD 2 14-pin Header (PIC16F684)
ICD 2 14-pin Header (PIC16F688)
ICD 2 14-pin Header (PIC16F638/636)
ICD 2 Module ws
ICD 2 Evaluation Kit
The Universal
Programming Module is
a handy low-cost tool to
support programming of
DIP packaged products
from Microchip.
It can be used in
conjunction with the
In-Circuit Debugger
MPLAB ICD 2 Header Interfaces
The header interface provides In-Circuit Debugging
capability to the 8-pin, 14-pin or 18-pin devices. The
header interface is connected in place of the target
device and houses a standard MPLAB ICD 2
connector. In-circuit debugging is done via a MPLAB
ICD 2. Once the code is debugged, the debugged
software can then be programmed into the device and
installed in the board replacing the header.
MPLAB ICD Header Interface
A handy device that plugs into the existing 40-pin DIP
socket on the development board where a Flash-based
microcontroller would be. It breaks the connection to
RB5, RB6 and RB7, which are then connected to the
standard MPLAB ICD connector. This provides access
for immediate in-circuit debugging without having to
accommodate hardware on your board.
© 2004 Microchip Technology Inc.