ATAB8402 Atmel, ATAB8402 Datasheet - Page 16

• Manufacturer Part Number: ATAB8402
• Description: BOARD DEMO 433MHZ RF TRANSMITTER
• Manufacturer: Atmel
• Type: Transmitterr

Specifications of ATAB8402

• Frequency: 433MHz
• Wireless Frequency: 315 MHz
• Modulation: ASK, FSK
• For Use With/related Products: ATA8402
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4. Operating of Transmitter Demo board with RF Design Kit
16
ATA8401/ATA8402/ATA8403
Transmitter demo boards ATAB8401/02/03 show the feature ISP (in system programmable) and
can be used as an example of a stand-alone RF remote control transmitter that offers ASK and
FSK modulation. To evaluate the transmitter, Atmel offers a microprocessor board ATAB-RFMB
(ATAB-STKFLamingo) to configure the IC as well as the evaluation software RF Design Kit. This
section provides some important information needed to start the evaluation with the microcon-
troller board. For the complete description of both RF Design Kit and ATAB-RFMB
(ATAB-STKFlamingo), please refer to the application notes “ATAK57xx and ATAK862xx hard-
ware description” and “ATAK57xx, ATAK57xx-F, ATAK862xx and ATAK862xx-F software
description”.
Technical features:
Configuration of the transmitter:
• Power supply: 3V Lithium cell (e.g. CR2032)
• Frequency deviation: approximately. 30 kHz
• Printed loop antenna
• Three programmable buttons
• No hardware changing is necessary for the verification of two different modulation schemes.
• In-system configuration of the software setting to the EEPROM of the microcontroller
• The transmitter demo board is tested under the ETSI as well as FCC regulation. The test
• Connect the microcontroller board (ATAB-RFMB or ATAB-STKFlamingo) to a PC using a
• Switch on the 12V power supply of the microcontroller board
• Start the RF Design Kit software (see
• Select the transmitter drop-down menu to choose the setting of a transmitter. The setting
• Remove the lithium cell battery from the holder
• Plug the transmitter into the adapter PCB of the microcontroller board
T48C893N is possible using the programming adapter JP1
results show that the transmitter can be applied in real applications and pass the type
approval
serial link cable (RS232). Please use the free serial port (Com1 or Com2).
software for T5750/53/54 is the same as for verification with ATA8401/ATA8402/ATA8403.
(Figure 4-2 on page
– Choose T5753 (315 MHz) for configuration of ATAB8401
– Choose T5754 (315 MHz) for configuration of ATAB8402
– Choose T5750 (868 MHz) for configuration of ATAB8403-8
– Choose T5750 (915 MHz) for configuration of ATAB8403-9
17)
Figure 4-1 on page
17)
9115A–INDCO–01/08