RN-24S Roving Networks Inc, RN-24S Datasheet - Page 27

• Manufacturer Part Number: RN-24S
• Description: SUPERMODULE BLUETOOTH CHIP ANT
• Manufacturer: Roving Networks Inc

Specifications of RN-24S

• Frequency: 2.4GHz
• Data Rate - Maximum: 721kbps
• Modulation Or Protocol: Bluetooth v2.0+EDR, Class 1 & 2
• Applications: Bluetooth v2.0
• Power - Output: 4dBm
• Sensitivity: -80dBm
• Voltage - Supply: 4 V ~ 24 V
• Current - Receiving: 40mA
• Current - Transmitting: 40mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: On-Board, Chip
• Package / Case: Module
• Wireless Frequency: 2.402 GHz to 2.48 GHz
• Interface Type: UART
• Data Rate: 240 Kbps to 300 Kbps
• Modulation: FHSS, GFSK
• Operating Voltage: 3.3 V
• Antenna: Chip Antenna
• Board Size: 20.32 mm x 50.8 mm x 4.08 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1008

Appendix A: Bluetooth Evaluation Board
The Roving Networks Bluetooth Evaluation
board has several interfaces for configuration
and programming. These are listed below in the
table. The board is powered by and external
5VDC power plug or through pin 9 in the DB9
connector.
The Bluetooth radio same command set and
configuration parameters are consistent across all
Roving Networks Bluetooth modules, serial
adapters and USB dongles so applications can be
developed using the evaluation board and run on
embedded Bluetooth module such as the RN-41
or RN-24.
Power Terminals
Inputs on P1 power connector can be 4.5VDC to 11.0VDC. There is internal regulation down to 3.3VDC for all
circuitry. Worst case power draw for the board is 100ma when the Bluetooth radio/modem connection is established
and transmitting. Power can be as low as 1ma to 25ma average when the Bluetooth radio/modem is not connected
depending on parameter settings.
Default LED status
www.rovingnetworks.com
T
physical monitor of the actual voltage, and is not driven by software in the module.
he yellow LED blinks when data is transferred on either the RX or TX pins of the DB9 serial port. It is a
809 University Avenue
Configuring
Startup/Config Timer
Discoverable/Inquiring/Idle
Connected
•
MODE
Los Gatos, CA 95032
~ 27 ~
•
Tel [phone]
(J2) 6 pin
SPI I/O
LEDs
GREEN LED blink rate
Bluetooth Evaluation Board
10 times per second
2 times per second
Once per second
rn-bluetooth-um Version 4.77 1/24/2011
Advanced User Manual
Solid ON
• [e-mail]
(J1) 9 pin Serial
3.3 VDC
(P1) 5VDC
Center pin
Positive
(CN1) 9 pin
RS232