X09-019NSC Digi International/Maxstream, X09-019NSC Datasheet - Page 31

• Manufacturer Part Number: X09-019NSC
• Description: MOD RF 900MHZ 19.2K W/RPSMA CONN
• Manufacturer: Digi International/Maxstream
• Series: XStream™r

Specifications of X09-019NSC

• Frequency: 900MHz
• Data Rate - Maximum: 19.2kbps
• Modulation Or Protocol: FSK
• Power - Output: 100mW
• Sensitivity: -110dBm
• Voltage - Supply: 5V
• Current - Receiving: 50mA
• Current - Transmitting: 140mA
• Data Interface: PCB, Through Hole
• Antenna Connector: RP-SMA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -

XStream™ OEM RF Module – Product Manual v5.x00 [2006.02.24]
RS (RSSI) Command
RT (DI2 Configuration) Command
RZ (DI Buffer Size) Command
SB (Stop Bits) Command
SH (Serial Number High) Command
<Diagnostics> Read the signal level of the last
packet received. This reading is useful for
determining range characteristics of the modules
under various conditions of noise and distance.
Once the command is issued, the module will
return a value between 0x06 and 0x36. (‘0x36’
represents a very strong signal level and ‘0x06’ indicates a low signal level.)
<Serial Interfacing> RT command is used to
dictate the behavior of the DI2/
Command must be issued to enable
control or binary programming.
<Diagnostics> The RZ command is used to read
the size of the DI buffer (UART RX (Receive)).
Note: The DO buffer size can be determined by
multiplying the DI buffer size by 1.5.
<Serial Interfacing> Set/Read the number of
stop bits in the RF data packets.
<Diagnostics> Set/Read the serial number high
word of the module.
© 2006 MaxStream, Inc. Confidential and Proprietary
/CMD line. RT
flow
AT Command: ATRZ
Binary Command: 0x2C (44 decimal)
Parameter Range: Read-only
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
AT Command: ATRS
Binary Command: 0x1C (28 decimal)
Parameter Range: 0x06 – 0x36 [read-only]
Number of bytes returned: 1
Minimum Firmware Version Required: 4.22
AT Command: ATRT
Binary Command: 0x16 (22 decimal)
Parameter Range: 0 – 2
Default Parameter Value: 0
Number of bytes returned: 1
AT Command: ATSB
Binary Command: 0x36 (54 decimal)
Parameter Range: 0 – 1
Default Parameter Value: 0
Number of bytes returned: 1
Minimum Firmware Version Required: 4.2B
AT Command: ATSH
Binary Command: 0x25 (37 decimal)
Parameter Range: 0 – 0xFFFF [read-only]
Number of bytes returned: 2
Related Commands: SL (Serial Number Low)
Minimum Firmware Version Required: 4.27C
Parameter
Parameter
0
1
2
0
1
Enable Binary Programming
Enable
Configuration
Configuration
1 stop bits
2 stop bits
disabled
Flow Control
31