X09-009NSC-TX Digi International/Maxstream, X09-009NSC-TX Datasheet - Page 54

• Manufacturer Part Number: X09-009NSC-TX
• Description: MOD RF TX 900MHZ 9600BPS W/RPSMA
• Manufacturer: Digi International/Maxstream

Specifications of X09-009NSC-TX

• Frequency: 900MHz
• Data Rate - Maximum: 19.2kbps
• Modulation Or Protocol: FSK
• Power - Output: 100mW
• Sensitivity: -110dBm
• Voltage - Supply: 5V
• Current - Receiving: 50mA
• Current - Transmitting: 140mA
• Data Interface: PCB, Through Hole
• Antenna Connector: RP-SMA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -

XStream™ OEM RF Module – Product Manual v5.x00 [2006.02.24]
Automatic DIP Switch Configurations
Each time the module assembly (XStream Module mounted to an XIB-R Interface Board) is
powered on, intelligence on t
the module based on positions
the pow
To avoid overwriting previous
configurations that take place
disable a processor located on
the XIB-R Interface Board. By
Table B‐02. Module Power‐up Option
Condition
If J7 is popu
If Config Switch is pressed
If J7 is NOT populated and Config Switch
is NOT pressed
Table B‐03. AT Commands Sent as result of DIP Switch Settings (SW = DIP Switch)
Condition
Restore Default Parameter Values of the Module
If SW1 & SW2 are ON (up)
Serial Interfacing Options
If SW1 is ON (up)
If SW1 is OFF (down)
Parity Options
If SW5 & SW6 are OFF (down)
If SW5 is OFF (down) & SW6 is ON (up)
If SW5 is ON (up) & SW6 is OFF (down)
If SW5 is ON (up) & SW6 is ON (up)
Exit AT Command Mode
Always
© 2006 MaxStream, Inc. Confidential and Proprietary
er-on sequence affect
lated
he MaxStream Interface
ly stored custom configurations
module parameter values as shown below.
each time the mo
default, J7 jumper is not populated.
the XIB-R inte
of the DIP Switch. Automatic configurations that take place d
Behavior
Processor is disable
Processor is disabled and Module enters into AT Command Mode.
Execute logic as shown in table below.
Behavior
AT Commands sent:
AT Commands sent:
AT Commands sent:
AT Commands sent:
AT Commands sent:
AT Commands sent:
AT Commands sent:
AT Commands sent:
s (J7 jumper and Config Switch)
rface board. To disable the processor, populate J7 of
d and AT Commands are not sent to the Module.
dule assembly is powered on), it is necessary to
ATRE (Restore Defaults) Command
ATWR (Write) Command
ATCS 0 (RS-232 Operation: CTS function for CTS line,
DB-9 pin 8)
ATCD 2 (DO3 - RX LED = low)
ATCS 3 (RS-485 or RS-422 Operation)
ATCD 2 (DO3 - RX LED = low)
ATNB 0 (parity = none)
ATNB 1 (parity = even)
ATNB 2 (parity = odd)
ATNB 5 (parity = 9th bit data over-the-air)
ATCN (Exit AT Command Mode)
Board sends AT Commands that program
(due to the automatic
uring
54