ZB2430-Q-E-S-U Laird Technologies, ZB2430-Q-E-S-U Datasheet - Page 50

• Manufacturer Part Number: ZB2430-Q-E-S-U
• Description: MOD ANT CONN ZIGBEE 2-100MW U.FL
• Manufacturer: Laird Technologies
• Series: AeroCommr

Specifications of ZB2430-Q-E-S-U

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: AMR, ISM, Security and Access
• Power - Output: 10dBm ~ 20dBm
• Sensitivity: -99dBm
• Voltage - Supply: 3 V ~ 3.5 V
• Current - Receiving: 27mA
• Current - Transmitting: 25mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

A
Some applications may require a more extensive knowledge of the Network and its current configuration. For this
reason, the ZB2430 includes several advanced commands which can be issued anytime the radio is in Command
mode. Each of these commands include a 16-bit Return Mask which allows the OEM Host to select the information
returned in the command response.
Note: All unused bits in the Return Mask should be set to “0”.
R e a d N e i g h b o r T a b l e
The Neighbor Table is stored in NV RAM in stores information about neighboring devices which are operating with teh
same Channel Mask, but no necessarily the same channel. The command format is shown in Figure 17.
Command Definitions
After issuing the Read Neighbor Table command, the radio will respond with the requested information as shown in
Figure 18 below. The actual command response format may vary depending on the Return Mask setting used in the
command.
*Note: Command will only fail if more than the maximum number of neighbors is requested.
Start Delimiter
DVANCED
• Start Index: Starting index within the Neighbor Table to begin reporting.
• Count: Number of entries to include in Neighbor Table. Maximum number of indexes = 8 (Coordinator and
• Index Number: Index location of radio in Route Table.
• NWK Address: 16-bit NWK address of the neighboring device.
• PAN ID: The 16-bit PAN ID of the network to which the device belongs.
• TX Cost: Counter of transmission (success/failures)
• RX Cost: Average of received RSSI values for the specified device
0xCC
Routers) and 4 (End Devices).
0x00: Show all Entries between
Start index and Maximum (Max =
8 for Coordinators/Routers, Max =
4 for End Devices)
0x01-n: Show Entries between
Start Index and Start Index +
Count – 1.
Command Identifier
Count (Byte 3)
F i g u r e 1 7 : R e a d N e i g h b o r T a b l e C o m m a n d
0x88
N
ETWORK
www.aerocomm.com
Request
0x00: Index to start
reporting at
Data
Start Index (Byte 4)
C
OMMANDS
Bit 0: Index Number
Bit 1: Network Address
Bit 2: PAN ID
Bit 3: TX Cost
Bit 4: RX Cost
Bit 5: Security Key Sequence Number
Bit 6: Security Frame Counter
Bit 7-15: Reserved. Set to 0.
Return Mask (Bytes 5-6)
11