MICRF102YM Micrel Inc, MICRF102YM Datasheet - Page 5

• Manufacturer Part Number: MICRF102YM
• Description: IC ASK TRANSMITTER UHF 8SOIC
• Manufacturer: Micrel Inc

Specifications of MICRF102YM

• Frequency: 300MHz ~ 470MHz
• Applications: RKE
• Modulation Or Protocol: ASK, OOK
• Data Rate - Maximum: 20 kbps
• Power - Output: -4dBm
• Current - Transmitting: 4.7mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 4.75 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Data Rate: 20Kbps
• Frequency Range: 300MHz To 470MHz
• Modulation Type: ASK
• Rf Ic Case Style: SOIC
• No. Of Pins: 8
• Supply Voltage Range: 4.75V To 5.5V
• Operating Temperature Range: -40°C To +85°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 576-1338

6.0 RELIABILITY TEST
6.1 REFLOW PROFILE
The Power Of Linking Together
No.
1
2
3
4
5
6
7
8
9
ABRACON
CORPORATION
Temperature Cycling:
Gross Leak Test:
Fine Leak Test:
Thermal Shock:
Solderability:
Test Items
(ABLS only)
Lead Bend:
Drop Test:
Vibration:
Humidity:
Drawing No. :
The component shall remain within the electrical specification (± 5 pp
max) after 3 cycles of high and low temperature testing (-40°C to
+85°C) for 2 hours max.
The component shall remain within the electrical specification after
exposure at extreme temperature -40°C to +85°C for 5 minutes for 3
cycles.
The component shall remain within the electrical specification after
loaded vibration at 10Hz to 55Hz, amplitude 1.5mm, within 1 minute
for 2 hours minimum on each axis (X,Y,Z).
The component shall remain within the electrical specifications after a
natural drop (3X) on a hard wooden board at 75 cm.
The component shall remain within the electrical specifications after
being kept at a condition of ambient temperature +85°C, 85% RH for
96 hours minimum.
Expose samples to 60PSIG Helium gas for 2 hours.
Max leak rate 2X10-8atmcc/s.
Submerge samples in 100% De-ionized water or Perfluorocarbon at
85°C for at least 1 minute. Check for bubbles.
Solderability of terminals shall be kept at more than 95% after dipped
in solder flux at 260°C ± 5°C for 5 seconds.
The component shall withstand maximum bend of 90°C
reference to base for 2 bends. Solder tinning must be
4 microns thick minimum.
-------
Test Conditions
Rev. -
Page 5 of 7