PS21964-4 Powerex Inc, PS21964-4 Datasheet - Page 7

• Manufacturer Part Number: PS21964-4
• Description: MOD IPM 600V 15A SUPERMINIDIP
• Manufacturer: Powerex Inc
• Series: Intellimod™r
• Type: IGBTr

Specifications of PS21964-4

• Configuration: 3 Phase
• Current: 15A
• Voltage: 600V
• Voltage - Isolation: 1500VDC
• Package / Case: PCB Module
• Dc Collector Current: 15A
• Collector Emitter Voltage Vces: 600V
• Power Dissipation Pd: 33.3W
• Collector Emitter Voltage V(br)ceo: 600V
• Operating Temperature Range: -20°C To +100°C
• No. Of Pins: 25
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DK-PS21964 - KIT DEV INTERFACE IPM MINIDIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 835-1042

PS21964-4, PS21964-4A, PS21964-4C
Intellimod™ Module
Dual-In-Line Intelligent Power Module
15 Amperes/600 Volts
Protection Function Timing Diagrams
Typical Interface Circuit
Wiring Method Around Shunt Resistor
Rev. 12/09
Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697-1800 [phone]
MCU
Under-Voltage Protection (Upper-side, UV DB )
OUTPUT CURRENT I C
CONTROL SUPPLY
FAULT OUTPUT F O
CONTROL INPUT
CIRCUIT STATE
C1: Control supply voltage rises – After the voltage level reaches UV DBr , the drive circuit begins to work
C2: Normal operation – IGBT turn on and conducting current.
C3: Under-voltage trip (UV DBt ).
C4: IGBT stays off regardless of the control input level, but there is no F O signal output.
C5: Under-voltage reset (UV Dr ).
C6: Normal operation – IGBT turn on and conducting current.
VOLTAGE V DB
PROTECTION
V NC
at the rising edge of the next input signal.
DIP-IPM
UV DBr
N
10kΩ
HIGH LEVEL (NO FAULT OUTPUT)
RESET
5V LINE
C1
R SHUNT (Chip type resistor is recommended.)
Wiring inductance should be less than 10nH.
(Equivalent to the inductance of a copper pattern with
length = 17mm, width = 3mm, and thickness = 100um.)
UV Dt
U P , V P , W P , U N , V N , W N
V NC (LOGIC)
F O
C2
DIP-IPM
This GND wiring from V NC should be as
close to the shunt resistors as possible.
SET
C3
C4
3.3kΩ (MIN)
RESET
C5
NOTE: RC coupling at each input
(parts shown dotted) may change
depending on the PWM control
scheme used in the application and
the wiring impedance of the printed
circuit board. The DIP-IPM input signal
section integrates a 3.3k Ω (min)
pull-down resistor. Therefore, when
using an external filtering resistor, care
must be taken to satisfy the turn-on
threshold voltage requirement.
C6
7