EE-SX870R Omron, EE-SX870R Datasheet - Page 7

• Manufacturer Part Number: EE-SX870R
• Description: OPTO SENSOR 5MM LIGHT-ON
• Manufacturer: Omron

Specifications of EE-SX870R

• Sensing Distance: 0.197" (5mm)
• Sensing Method: Transmissive
• Output Configuration: PNP - Open Collector/Light-ON
• Mounting Type: Chassis Mount, M3 Screw
• Current - Supply: 30mA
• Voltage - Supply: 5 V ~ 24 V
• Package / Case: Module, Pre-Wired
• Lead Free Status / RoHS Status: Contains lead / RoHS compliant by exemption
• Response Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: EESX870R

EE- -SX770/771/772/870/871/872(A/P/R)
Precautions
7
J MOUNTING
•
•
•
•
•
J OPERATING ENVIRONMENT
•
•
•
•
The EE-SX77/87 is a photomicrosensor that should be built
into equipment. For this reason, no special protective mea-
sures have been taken to protect the EE-SX77/87 from ex-
ternal light disturbance. Avoid malfunction by ensuring that
the EE-SX77/87 is not influenced by incandescent lamps or
other light sources that may cause external light distur-
bance.
Mount the photomicrosensor securely to flat plates. The
characteristics of the through-beam sensor change if the
slot is deformed.
Use M3 screws when mounting the EE-SX77/87. Be sure to
use spring washers with the screws, so that the screws will
not loosen. The tightening torque applied to each screw
must be no more than 0.59 N S m (6 kgf S cm).
Make sure that nothing will come into contact with the sens-
ing element of the sensor. If the sensing element has
scratch damage, the operating characteristics of the photo-
microsensor will decrease.
Securely mount the EE-SX77/87 to prevent loosening by
vibration or shock.
Do not connect the EE-SX77/87 while power is applied, or
the EE-SX77/87 may be damaged.
Do not install the EE-SX77/87 in the following locations to
avoid malfunction or damage:
Make sure that the operating ambient temperature is within
the rated range.
The photomicrosensor may be soluble in organic solvent,
acid, and alkaline, aromatic hydrocarbon, and chlorinated
aliphatic hydrocarbon solvents. The characteristics of the
photomicrosensor may decrease as a result. Make sure that
the photomicrosensor is free from these solutions.
A. Locations with excessive dust
B. Locations with corrosive gas
C. Locations where water, oil, or chemicals are directly
D. Locations exposed to direct sunlight
sprayed
J TO AVOID DAMAGE
•
Sensor
•
Sensor
•
Sensor
!
Do not use the EE-SX77/87 at voltage exceeding the rated
voltage range.
Do not make mistakes in wiring, such as mistakes in polarity.
Do not short-circuit the load (i.e., do not connect a power
supply directly to the Sensor) as shown below.
Brown
Brown
Brown
Caution
Black
Blue
Black
Blue
Black
Blue
EE- -SX770/771/772/870/871/872(A/P/R)
Load
Load
Load
Load
short-circuiting