A22K-2AL-01 Omron, A22K-2AL-01 Datasheet - Page 42

• Manufacturer Part Number: A22K-2AL-01
• Description: SWITCH KEYLOCK 2POS MOM SPST-NC
• Manufacturer: Omron
• Series: A22Kr

Specifications of A22K-2AL-01

• Circuit: SPST-NC
• Number Of Positions: 2
• Contact Rating @ Voltage: 10A @ 110VAC
• Actuator Type: Flat Key
• Mounting Type: Panel Mount
• Termination Style: Screw Terminal
• Key Removable Positions: Left
• Angle Of Throw: 90°
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A22K2AL01

Square Pushbutton/Indicator
Removing the Color Lens:
Insert the protruding tip of the Lens Puller (A3PJ-5080) into the lens
slot, hold the plate spring, and pull them to remove the Color Lens.
Mounting the Color Lens:
Mount the Color Lens on the flange and firmly push the Color
Lens. When the Color Lens is inserted, check whether it operates
properly. When replacing the Lamp, remove the Color Lens and
diffusion plate with fingers or Lens Puller.
Attach the Character Film properly so that it fits inside the
protruding part of the diffusion plate. Then, match the diffusion
plate to the square flange and insert the Lens.
J EMERGENCY STOP SWITCH
Insert the protrusion of the Tightening Wrench (A22Z-3905) into
the Cap slot and then turn to remove the Cap.
J INSTALLING/REPLACING THE LAMP
Installing from the Panel Surface
Insert the Lamp Extractor (A22Z-3901) into the lamp, then rotate the
Extractor while pressing it.
Common To All Assemblies
Plate spring
Diffusion plate
Character Film
Flange
Color Lens
43
Installing/Replacing on the Switch Unit
Grip the indicator with your fingers, then rotate the indicator while
pressing it against the Switch Unit.
J CONTROL BOX (ENCLOSURE)
Mounting the Switch
The Standard-size Legend Plate Frame can be mounted. Mount
the Frame as shown in the following diagram. Mount the Switch
in the same way as for an ordinary panel.
J INSTALLING/REMOVING THE SWITCH
Installing the Switch Unit
Hook the small protrusion on the Switch Unit into the groove on the
other side of the lever, then push up the Switch Unit in the direction
indicated by the arrow in the figure below.
UNIT
Mounting
Latch
Common To All Assemblies
Snap-in Legend Plate
Switch Unit
Protrusion
Lever