JWL11RC2A NKK Switches, JWL11RC2A Datasheet - Page 9

• Manufacturer Part Number: JWL11RC2A
• Description: SW ROCKER SPST 16A RED CAP VERT
• Manufacturer: NKK Switches
• Series: JWr
• Type: Internationally Approved TV Rated Rockersr

Specifications of JWL11RC2A

• Circuit: SPST
• Switch Function: On-Off
• Contact Rating @ Voltage: 16A @ 125VAC
• Illumination: Non-Illuminated
• Mounting Type: Panel Mount, Snap-In
• Termination Style: Solder, Quick Connect - .187" (4.7mm)
• Panel Cutout Dimensions: 29.50mm x 20.50mm
• Contact Form: SPST
• Contact Rating: 16 Amps at 125 Volts
• Actuator: Rocker
• Color: Black
• Mounting Style: Panel
• Terminal Seal: Epoxy
• Contact Plating: Silver
• Features: Combination of dust cover, housing, actuator, pivot provides protection for contacts
• Voltage Rating Ac: 250 VAC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Illumination Type, Color: -
• Illumination Voltage (nominal): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

B
Series JW
B48
Operating Environment
• Do not install switch where heavy dust collection occurs. Dust build-up under rocker may affect switch actuation.
• Do not actuate switch if submerged in water or oil.
• Installation is not recommended on horizontal surface in an environment where frequent splashing of
Panel Mounting
• Before snapping a switch into the panel, align the gasket evenly under bezel of the switch.
• When mounting into a panel, apply equal pressure to sides of bezel and insert parallel to panel.
• After mounting a switch, be sure there are no gaps between switch and panel.
• After installing into panel, do not apply excessive force.
• After panel installation and wiring is completed, do not apply force horizontally
• Behind the panel, cut area should be squared. If front of panel is painted, do not allow any paint to collect in
• Avoid reinstalling a switch once it has been mounted in a panel. This may cause deterioration of panel sealability.
water may occur. In such an environment, a minimum 30° angle installation is advisable. If there is
a possibility of freezing, install vertically so no moisture will be retained within switch housing.
Lightly push into panel.
or vertically from behind panel.
corners of cutout to prevent level mounting.
PRECAUTIONS FOR HANDLING & STORAGE FOR JWMW/LW (PANEL SEAL TYPES)
www.nkk.com
High Inrush 10 & 16 Amp Rockers
Incorrect
Correct
Clean Edges
30°