PIC-MAXI-WEB Olimex Ltd., PIC-MAXI-WEB Datasheet - Page 3

• Manufacturer Part Number: PIC-MAXI-WEB
• Description: MCU, MPU & DSP Development Tools TCP-IP DEV BRD FOR PIC18F97J60
• Manufacturer: Olimex Ltd.

Specifications of PIC-MAXI-WEB

• Processor To Be Evaluated: PIC18F97J60
• Data Bus Width: 8 bit
• Interface Type: RS-232, Ethernet
• Dimensions: 120 mm x 108 mm
• Operating Supply Voltage: 9 V to 25 V
• Tool Type: Development Kit
• Core Architecture: PIC
• Cpu Core: PIC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1701534 25R4923

PROCESSOR FEATURES:
need a serial cable if not for programming, than for configuring the board.
You will also need a LAN cable.
Hardware: Programmer/Debugger –Olimex programmers are applicable,
!!!Warning!!! When you want to program this microcontroller with PIC-
Software:
PIC-MAXI-WEB board use MCU PIC18F97J60 from Microchip with these
features:
-
-
-
-
-
-
-
-
-
-
-
IEEE 802.3 compatible Ethernet Controller
Integrated MAC and 10Base-T PHY
8-Kbyte Transmit/Receive Packet Buffer SRAM
Supports One 10Base-T Port
Programmable Automatic Retransmit on Collision
Programmable Padding and CRC Generation
Programmable Automatic Rejection of Erroneous Packets
Activity Outputs for 2 LED Indicators
Buffer:
MAC:
PHY:
o
o
o
o
o
o
o
o
Configurable transmit/receive buffer size
Hardware-managed circular receive FIFO
Byte-wide random and sequential access
Internal DMA for fast memory copying
Hardware assisted checksum calculation for various protocols
Support for Unicast, Multicast and Broadcast packets
Programmable Pattern Match of up to 64 bytes within packet at
user-defined offset
Programmable wake-up on multiple packet formats
for example PIC-ICD2, PIC-ICD2-POCKET, PIC-ICD2-TINY or
other compatible programming/debugging tool.
ICD2, PIC-ICD2-POCKET or PIC-ICD2-TINY, before
connecting the programmer to your target board, you should
first connect the programmer to your computer and open
MPLAB. There, first from menu Configure – Select Device –
choose the microcontroller you are about to program, then from
menu Programmer – Select Programmer – choose MPLAB ICD
2, wait while MPLAB is downloading operation system, and
after ICD2 is connected – check in menu Programmer –
Settings – Power – there is option – Power target circuit from
MPLAB ICD 2 – this option should be forbidden, you could not
select it. Now it is safe to connect the programmer to your
target board.
PIC-WEB is tested with MPLAB IDE v.7.62 + MPLAB C18 C
compiler. It is possible that the stack might not function
properly if used with later versions of MPLAB IDE.
You will also need a terminal program configured at 19 200
bps, 8N1 and no flow control.
Page 3