Programmers & Debuggers ProASIC Programmer

FLASHPRO4

Manufacturer Part NumberFLASHPRO4
DescriptionProgrammers & Debuggers ProASIC Programmer
ManufacturerActel
FLASHPRO4 datasheet
 


Specifications of FLASHPRO4

Positions/sockets1Lead Free Status / RoHS StatusLead free / RoHS Compliant
For Use With/related ProductsFPGAs  
1
Page 1
2
Page 2
Page 1/2

Download datasheet (110Kb)Embed
Next
FlashPro4 Device Programmer
Quickstart Card
This quickstart card applies only to the FlashPro4 device programmer.
Kit Contents
Quantity
1
FlashPro4 programmer standalone unit
1
USB A to mini-B USB cable
1
FlashPro4 10-pin ribbon cable
Software Installation
If you are already using Actel's Libero® Integrated Design Environment (IDE), you have the
FlashPro software installed as part of Libero IDE. If you are using the FlashPro4 device programmer
for standalone programming or on a dedicated machine, download and install the latest release of the
FlashPro software from the Actel website. The installation will guide you through the setup.
Complete the software installation before connecting the FlashPro4 device programmer to your PC.
Note:
Libero IDE v8.6 SP1 or FlashPro v8.6 SP1 are the minimum versions required to run
FlashPro4.
Software releases: www.actel.com/download/program_debug/flashpro.
Hardware Installation
After installing the software successfully, connect one end of the USB cable to the FlashPro4 device
programmer and the other end to your PC’s USB port. The Found Hardware Wizard will open twice.
Use the wizard to install the driver automatically (recommended). If the Found Hardware Wizard
cannot find the drivers automatically, then ensure you have properly installed the FlashPro software
prior to installing the hardware. If the drivers still cannot be installed automatically, then install them
from a list or specific location (advanced).
If FlashPro was installed as part of the Libero IDE default installation, the drivers are located at
C:/Libero/Designer/Drivers/Manual. For a standalone FlashPro default installation, the drivers are
located at C:/Actel/FlashPro/Drivers/Manual. Actel recommends the automatic driver installation.
© 2010 Actel Corporation. All rights reserved.
Description

FLASHPRO4 Summary of contents

  • Page 1

    ... Software releases: www.actel.com/download/program_debug/flashpro. Hardware Installation After installing the software successfully, connect one end of the USB cable to the FlashPro4 device programmer and the other end to your PC’s USB port. The Found Hardware Wizard will open twice. Use the wizard to install the driver automatically (recommended). If the Found Hardware Wizard cannot find the drivers automatically, then ensure you have properly installed the FlashPro software prior to installing the hardware ...

  • Page 2

    ... Pin 4 on FlashPro4 programmers MUST NOT be connected or used for anything other than its intended purpose. Common Issues If the On LED does not light up after FlashPro4 driver installation, the driver might not be installed correctly and you must troubleshoot the installation. For more information, refer to the Software and Hardware Installation Guide FlashPro software release notes: www ...