B32633A1223J10 EPCOS Inc, B32633A1223J10 Datasheet - Page 21

• Manufacturer Part Number: B32633A1223J10
• Description: Polypropylene Film Capacitors 0.022uF 1600V 5% Crimped Leads
• Manufacturer: EPCOS Inc
• Series: B32633r

Specifications of B32633A1223J10

• Voltage Rating: 1.6 KVolts
• Termination Style: Radial
• Dimensions: 11.5 mm W x 27.5 mm L x 19.5 mm H
• Operating Temperature Range: - 55 C to + 110 C
• Dissipation Factor Df: 1
• Load Life: 200000 Hrs
• Product: Metallized Polypropylene Capacitors
• Capacitance: 0.022 uF
• Tolerance: 5 %
• Lead Spacing: 22.5 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: B32633A1223J010

1.3
Permissible heat exposure loads on film capacitors are primarily characterized by the upper cate-
gory temperature T
can lead to changes in the plastic dielectric and thus change irreversibly a capacitor's electrical
characteristics. For short exposures (as in practical soldering processes) the heat load (and thus
the possible effects on a capacitor) will also depend on other factors like:
The overheating associated with some of these factors can usually be reduced by suitable coun-
termeasures. For example, if a pre-heating step cannot be avoided, an additional or reinforced
cooling process may possibly have to be included.
EPCOS recommends the following conditions:
Uncoated capacitors
For uncoated MKT capacitors with lead spacings 10 mm (B32560/B32561) the following mea-
sures are recommended:
Please read Cautions and warnings and
Important notes at the end of this document.
Pre-heating temperature and time
Forced cooling immediately after soldering
Terminal characteristics:
diameter, length, thermal resistance, special configurations (e.g. crimping)
Height of capacitor above solder bath
Shadowing by neighboring components
Additional heating due to heat dissipation by neighboring components
Use of solder-resist coatings
Pre-heating with a maximum temperature of 110 C
Temperature inside the capacitor should not exceed the following limits:
When SMD components are used together with leaded ones, the leaded film capacitors should
not pass into the SMD adhesive curing oven. The leaded components should be assembled af-
ter the SMD curing step.
Leaded film capacitors are not suitable for reflow soldering.
pre-heating to not more than 110 C in the preheater phase
rapid cooling after soldering
MKP/MFP 110 C
MKT 160 C
General notes on soldering
max
. Long exposure to temperatures above this type-related temperature limit
Page 21 of 29
Very high pulse (wound)
B32632 ... B32634