PV36W104C01B00 Murata, PV36W104C01B00 Datasheet - Page 77

• Manufacturer Part Number: PV36W104C01B00
• Description: Trimmer Resistors - Multi Turn 100Kohms 10mm Square 25turn
• Manufacturer: Murata

Specifications of PV36W104C01B00

• Resistance: 100 KOhms
• Power Rating: 0.5 Watt (1/2 Watt)
• Operating Temperature Range: - 55 C to + 125 C
• Element Type: Cermet
• Product: Multi-Turn Trimmer Potentiometers
• Tolerance: 10 %
• Number Of Turns: 25
• Taper: Linear
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9
!Note
!Note
3. Cleaning
Uncontrolled mechanical force except usual rotation on
the hollow rotor of product, may cause big change of
electrical characteristic, big increase of rotational
torque or mechanical damage of product.
Therefore, please pay your attention on the following
points for your design.
1. The fixing method of product must be soldering by
2. Your connecting shaft must be sustained by your
1. Please make sure the connecting impedance is not to
2. To minimize the processing error and noise
76
PVS1 Series Notice
(1) Data install should be done plural times and
Reflow Soldering Standard Profile
Notice (Handling)
the terminals of product. And please don't fix by
screw cramping of supporting board which might
cause mechanical deformation of product.
bearing and any uncontrolled force should not
apply on the hollow rotor of product.
Notice (Other)
be less than 10M ohm. The rotary position sensor
is designed to connect the output terminal and A/D
port of the microprocessor directly. Therefore,
connecting impedance presupposes certain M ohm and
the contact resistance is set high.
influence which occur in rare cases, when data is
installed through the product, please note the
following items and program your software.
sensor is mounted to the PCB.
Continued from the preceding page.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
260
230
200
150
100
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specifications before ordering.
0
Pre-heating in air
60-120 sec.
(Melting zone)
40 sec. max.
Soldering
Gradual cooling
in air
Time
3. Before using rotary position sensor, please test
4. MURATA cannot guarantee rotary position sensor
(2) Data considered as error should be invalid.
(3) If suspicious data is found, the data should be
Cannot be cleaned because of open construction.
after assembly in your particular mass production
system.
integrity when used under conditions other than
those specified in this document.
applied the mean value.
re-installed.
R50E13.pdf 04.6.11