POE80U-560(G)-R PHIHONG USA, POE80U-560(G)-R Datasheet - Page 2

• Manufacturer Part Number: POE80U-560(G)-R
• Description: Plug-In AC Adapters 80W 56V 1.43A Single Port Injector
• Manufacturer: PHIHONG USA
• Type: Power Over Ethernetr

Specifications of POE80U-560(G)-R

• Mounting Style: POE
• Input Voltage (nominal): 90 VAC to 264 VAC
• Number Of Outputs: 1
• Output Power Rating: 80 W
• Output Voltage (channel 1): 56 V
• Output Current (channel 1): 0.72 A
• Dc Output Connector: RJ45 Connector
• Ac Plug Included/required: Included
• Commercial/medical: Commercial
• Brand/series: POE80U Series
• Configuration: Enclosed
• Mounting Type: Panel
• Output: 56 VDC @ 1.43 A
• Power, Output: 80 W
• Primary Type: AC-DC
• Voltage, Input: 90 to 264 VAC
• Voltage, Output: 56 VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

INPUT:
AC Input Voltage Range
85 to 264VAC
AC Input Voltage Rating
100 to 240VAC, 47-63Hz
AC Input Current
2.0A (RMS) maximum for 90VAC
1.2A (RMS) maximum for 240VAC
Leakage Current
3.5mA maximum @ 254VAC 60Hz
AC Inrush Current
50A (RMS) maximum for 115VAC
50A (RMS) maximum for 230VAC
OUTPUT:
Total Output Power
80W
DC Offset
No data degradation with DC imbalance 18mA per
min.
Ripple and Regulation
100mV maximum
Efficiency
75% (typical) at maximum load, and 120VAC 60Hz
Hold-up Time
10mS min. 120VAC and maximum load
Transient O/P Voltage Protection
60V maximum at switch on and off at any point on
AC line phase
ENVIRONMENTAL:
Temperature
Operation
Non-operation
Humidity
Operation
POE80U Characteristics
-40 to +55°C
-50 to +85°C
5 to 90%
EMC
FCC Part 15 Class B
EN55022 Class B
Isolation Test
Primary to Secondary: 4242VDC for 1 minute 10mA
Primary to Field Ground: 2121VDC for 1 minute
Output to Field Ground: 2121VDC
Immunity
ESD:
RS:
EFT:
Surge:
CS:
Voltage Dips
Harmonic:
Insulation Resistance
Primary to Secondary: >10M OHM 500VDC
Primary to Field Ground: >10M OHM 500VDC
IEEE 802.3af/at Interoperability
UNH Interoperability report available upon request
FEATURE:
Detection
12.5kohm detection resistor value required to turn
on full power 4 pair power.
Over Voltage/Current, Short Circuit Protection
Outputs equipped with short circuit protection and
overload protection as per 802.3af specifications
except max average pair current is 0.72A, Peak
1.4A per pair. The output can be shorted
permanently without damage
Indicators
Green LED 1: DC Power “OK”
Red LED: Fault detected
Green LED 2: Power detected “CONNECT” at
80W
Input Connector
IEC320 inlet 3 pin
Warranty
1 Year
EN61000-4-2. Level 3
EN61000-4-3. Level 2
EN61000-4-4. Level 2
EN61000-4-5. Level 3
EN61000-4-6. Level 2
EN61000-4-11
EN61000-3-2
WWW.PHIHONG.COM