FR02KR10P-R NKK Switches, FR02KR10P-R Datasheet - Page 6

• Manufacturer Part Number: FR02KR10P-R
• Description: DIP Switches / SIP Switches DIP 10 Ext Shaft-Org 0.1A 5VDC 2.54mm SMD
• Manufacturer: NKK Switches

Specifications of FR02KR10P-R

• Switch Type: DIP
• Actuator: Shaft, Plastic
• Termination Style: SMD/SMT
• Current Rating: 100 mA
• Operating Temperature Range: - 25 C to + 85 C
• Number Of Positions: 10
• Contact Rating: 100 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10mm Ultra-Thin SMT DIP Rotaries
www.nkkswitches.com
FR02F & FR02K
Soldering:
Manual Soldering: 390°C soldering iron tip temperature; 4 seconds time on terminal; 2 cycles
Reflow Soldering Recommended. See illustration and table.
Note: During Reflow Soldering process, set the switch to the following position: FR02FR10P, FR02FR16P, FR02KR10P, FR02KR16P: 0
position; FR02FC10P, FR02KC10P: 7 position; FR02FC16P, FR02KC16P: F position
Cleaning:
These devices are not process sealed. Hand clean locally using alcohol based solution to remove flux on surface of PCB.
Handling:
When installing, avoid putting mechanical stress on terminal area.
Note: The Reflow Solder profile above describes the printed circuit board (PCB) surface tem-
perature. Since PCB surface temperature and switch surface temperature will vary depending on
the height of switch, PCB material, and PCB thickness, ensure switch surface temperature does
not exceed 250°C. Contact factory if your conditions are more severe than above specifications.
Reflow Solder Profile
Preheat Temperature
Preheat Time
Heating Temperature
Heating Time
Peak Temperature (Surface)
Peak Time
Thickness of PCB
Cycles
Comments
0
7850 East Gelding Drive • Scottsdale, Arizona 85260
Phone [phone] • Toll Free 877.228.9655
PROCESSING
T1 Preheat
t1
T3
T2
Symbol
T1
T2
T3
t1
t2
t3
t3
t2
t = seconds
High Temperature
PCB with no Lead
180°C ~ 200°C
Not Specified
120 seconds
60 seconds
Profile A
1.6mm
230°C
250°C
2
1110