CBC-EVAL-10 Cymbet Corporation, CBC-EVAL-10 Datasheet - Page 6

• Manufacturer Part Number: CBC-EVAL-10
• Description: ENERCHIP CC SEH EVAL KIT
• Manufacturer: Cymbet Corporation
• Series: EnerChip™ CCr
• Type: Energy Harvestingr

Specifications of CBC-EVAL-10

• Main Purpose: Power Management, Renewable Energy
• Embedded: No
• Utilized Ic / Part: CBC3150, CBC51100
• Primary Attributes: Thin Film Rechargeable Solid State Battery
• Secondary Attributes: Solar Energy Harvester
• Maximum Operating Temperature: + 70 C
• Product: Power Management Development Tools
• For Use With/related Products: EnerChip CBC51100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 859-1012

After confirming the header pins are properly configured, simply connect the 2-wire cable assembly from the PV
panel to jumper J8. [Note polarity; red wire goes to the positive terminal, pin 1.]
Expose the PV panel to ambient light of greater than 200 Lux. The EnerChip storage devices on the CBC51100
module will begin to charge and power will be supplied to the load via header pins J9 and J10. The magnitude
of power available to the load will be a function of the ambient light, the angle of incidence of light to the PV
panel, and the state of charge of the EnerChips.
To verify that the circuit is operating properly, measure the voltage on any of the readily accessible test points:
The various header pins may also be used as test measurement points. Refer to the schematic of Figure 4.
Reference the CBC3150 data sheet for operating characteristics of the CBC3150.
Users may populate R2 and R3 to set the maximum power point of the DC transducer. See the CBC3150 data
sheet for recommended resistor values. Note that the resistor divider will present a parasitic load to the trans-
ducer.
DS-72-20 Rev A
Test Point
TP1
TP2
TP3
TP4
TP5
©2011 Cymbet Corporation • Tel: [phone] • www.cymbet.com
CBC-EVAL-10 EnerChip CC EH Evaluation Kit
Node Description
External Battery Terminals
System Ground
PV Input
Regulated Output
System Ground
Page 6 of 15