HEDS-5600#A06 Avago Technologies US Inc., HEDS-5600#A06 Datasheet - Page 8

• Manufacturer Part Number: HEDS-5600#A06
• Description: ENCODER OPT 2CH QUICK ASSM
• Manufacturer: Avago Technologies US Inc.
• Series: HEDSr
• Type: Optical Encoderr

Specifications of HEDS-5600#A06

• Output Type: Quadrature (Incremental)
• Encoder Type: Optical
• Pulses Per Revolution: 500
• Voltage - Supply: 5VDC
• Actuator Type: 1/4" Open Center
• Detent: No
• Built In Switch: No
• Mounting Type: Chassis Mount, Motors
• Orientation: Vertical
• Termination Style: Terminal Pins
• No. Of Channels: 2
• Rotational Speed Max: 30000rpm
• Supply Voltage Range: 4.5VDC To 5.5VDC
• Encoder Resolution: 500CPR
• Supply Voltage: 5V
• Encoder Output: Square Wave Digital Pulse
• Operating Temperature Range: -40°C To +100°C
• Rohs Compliant: Yes
• Detents: No
• Motion: Rotary
• Number Of Channels: 2
• Mounting Style: Through Hole
• Index Output: Not Indexed
• Encoder Signal: Digital
• Shaft Style: Round
• Shaft Diameter (mm): 6.35mm
• Operating Supply Voltage (typ): 5VDC
• Operating Temperature Min Deg. C: -40C
• Operating Temperature Max Deg. C: 100C
• Terminal Type: PC Pins
• Sensor Supply Voltage: 4.5VDC To 5.5VDC
• Leaded Process Compatible: Yes
• Output: Quadrature with Index
• Product: Kits
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Rotational Life (cycles Min): -
• Lead Free Status / Rohs Status: Compliant
• Other names: 516-2023

Mounting Considerations
The HEDS-5540 and 5640 three channel encoders and the
HEDM Series high resolution encoders must be aligned
using the aligning pins as specified in Figure 3, or using
the HEDS-8910 Alignment Tool as shown in Encoder
Mounting and Assembly.
The use of aligning pins or alignment tool is recommend-
ed but not required to mount the HEDS-5500 and 5600.
If these two channel encoders are attached to a motor
with the screw sizes and mounting tolerances specified
in the mechanical characteristics section without any
Figure 2. Mounting Holes.
Figure 4. Mounting with External Ears.
8
Figure 3. Optional Mounting Aids.
additional mounting bosses, the encoder output errors
will be within the maximums specified in the encoding
characteristics section. The HEDS-5500 and 5540 can be
mounted to a motor using either the two screw or three
screw mounting option as shown in Figure 2. The optional
aligning pins shown in Figure 3 can be used with either
mounting option. The HEDS-5600, 5640, and HEDM-5600
have external mounting ears which may be used for
mounting to larger motor base plates. Figure 4 shows the
necessary mounting holes with optional aligning pins and
motor boss.