DSPIC30F6014AT-20E/PF Microchip Technology, DSPIC30F6014AT-20E/PF Datasheet - Page 3

• Manufacturer Part Number: DSPIC30F6014AT-20E/PF
• Description: 16-bit MCU/DSP 30MIPS 144KB 80 TQFP 14x14x1mm T/R
• Manufacturer: Microchip Technology
• Series: dsPIC™ 30Fr

Specifications of DSPIC30F6014AT-20E/PF

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 20 MIPS
• Connectivity: CAN, I²C, SPI, UART/USART
• Peripherals: AC'97, Brown-out Detect/Reset, I²S, LVD, POR, PWM, WDT
• Number Of I /o: 68
• Program Memory Size: 144KB (48K x 24)
• Program Memory Type: FLASH
• Eeprom Size: 4K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 16x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 80-TQFP, 80-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DM300024 - KIT DEMO DSPICDEM 1.1DM300019 - BOARD DEMO DSPICDEM 80L STARTERDM300004-2 - BOARD DEMO DSPICDEM.NET 2DM300004-1 - BOARD DEMO DSPICDEM.NET 1AC164314 - MODULE SKT FOR PM3 80PFAC30F001 - MODULE SOCKET DSPIC30F 80TQFPXLT80PT2 - SOCKET TRANSITION ICE 80TQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

5. Module: Output Compare
© 2006 Microchip Technology Inc.
A glitch will be produced on an output compare pin
under the following conditions:
• The user software initially drives the I/O pin
• The output compare module is configured and
When these events occur, the output compare
module will drive the pin low for one instruction
cycle (T
Work around
None. However, the user may use a timer interrupt
and write to the associated PORT register to
control the pin manually.
high using the output compare module or a
write to the associated PORT register.
enabled to drive the pin low at some later time
(OCxCON = 0x0002 or OCxCON = 0x0003).
CY
) after the module is enabled.
dsPIC30F6011A/6012A/6013A/6014A
6. Module: Using OSC2/RC15 as Digital I/O
Table 20-2 (see below) from the “dsPIC30F6011A/
6012A/6013A/6014A Data Sheet” (DS70143A)
lists the device clock operational modes. The data
in the table is correct with the following exceptions:
• Digital I/O functionality is not operational in the
• CLKOUT functionality is only supported if the
FRC with PLL (4x, 8x and 16x PLL) Oscillator
mode.
EC or ERC Oscillator mode is actually selected
as the device clock source.
or CLKOUT
DS80242C-page 3