NTHS0805N04N2003JE Vishay, NTHS0805N04N2003JE Datasheet - Page 45

• Manufacturer Part Number: NTHS0805N04N2003JE
• Description: THERMISTOR NTC 200K OHM 5% 0805
• Manufacturer: Vishay
• Series: NTHSr
• Type: NTCr

Specifications of NTHS0805N04N2003JE

• Resistance In Ohms @ 25°c: 200K
• Resistance Tolerance: ±5%
• B Value Tolerance: ±3%
• B25/75: 4247K
• Mounting Type: Surface Mount
• Package / Case: 0805 (2012 Metric)
• Description Of Terminals: Leadless
• Mounting Style: Surface Mount
• Pin Count: 2
• Screening Level: Automotive
• Sensitivity Index: 4247K
• Resistance @ 25c: 200kohm
• Percentage Of Resistance Tolerance @ 25c: ±5
• Accuracy: ±3
• Operating Temperature Min Deg. C: -40C
• Operating Temperature Max Deg. C: 125C
• Product Length (mm): 2mm
• Product Depth (mm): 1.25mm
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS Compliant
• B0/50: -
• B25/50: -
• B25/85: -
• B25/100: -
• Operating Temperature: -
• Power - Max: -
• Lead Length: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 541-1134-2; NTHS0805N04N2003JE

October 29, 2008 S29GL-N_01_12
Notes
1. When Sector Address is specified, any address in the selected sector is acceptable. However, when loading Write-Buffer address
2. DQ7 may change simultaneously with DQ5. Therefore, DQ7 should be verified.
3. If this flowchart location was reached because DQ5= 1, then the device FAILED. If this flowchart location was reached because DQ1= 1,
4. See
locations with data, all addresses must fall within the selected Write-Buffer Page.
then the Write to Buffer operation was ABORTED. In either case, the proper reset command must be written before the device can begin
another operation. If DQ1= 1, write the Write-Buffer-Programming-Abort-Reset command. if DQ5= 1, write the Reset command.
Table 10.1 on page 51
DQ1 = 1?
and
D a t a
No
Yes
(Note 1)
Table 10.3 on page 53
(Note 3)
Figure 10.1 Write Buffer Programming Operation
(Note 2)
S29GL-N MirrorBit
Yes
S h e e t
No
Write next address/data pair
Write number of addresses
to program minus 1(WC)
Write first address/data
Write program buffer to
address = Last Loaded
Read DQ7 - DQ0 with
Write “Write to Buffer”
Last Loaded Address
flash sector address
and Sector Address
Read DQ7 - DQ0 at
Buffer Operation?
Sector Address
FAIL or ABORT
command and
WC = WC - 1
Abort Write to
DQ7 = Data?
DQ7 = Data?
DQ5 = 1?
Address
WC = 0 ?
for command sequences required for write buffer programming.
®
Flash Family
Yes
No
No
No
No
Yes
Yes
Yes
Part of “Write to Buffer”
Command Sequence
Write to buffer ABORTED.
Must write “Write-to-buffer
Abort Reset” command
Write to a different
sequence to return
sector address
to read mode.
PASS
45