B59100M1160A70 EPCOS Inc, B59100M1160A70 Datasheet

Page 1

PTC thermistors as limit temperature sensors Motor protection, single sensors Series/Type: B59100 Date: December 2009 © EPCOS AG 2009. Reproduction, publication and dissemination of this publication, enclosures hereto and the information contained therein without EPCOS' prior express consent is prohibited. ...

Page 2

Sensors Motor protection, single sensors Applications Thermal protection of winding in electric motors Limit temperature monitoring Features Thermistor pellet with insulating encapsulation Low-resistance type, steep R/T curve Silver-plated and PTFE-insulated AWG 26 litz wires Extremely fast response due to small ...

Page 3

Sensors Motor protection, single sensors Electrical specifications and ordering codes sense ( sense sense (V 2 PTC PTC 570 570 70 570 570 80 570 570 90 ...

Page 4

Sensors Motor protection, single sensors Reliability data Test Standard Electrical endurance, IEC 60738-1 cycling Electrical endurance, IEC 60738-1 constant Damp heat IEC 60738-1 Rapid change IEC 60738-1 of temperature Vibration IEC 60738-1 Please read Cautions and warnings and Important notes ...

Page 5

Sensors Motor protection, single sensors Characteristics (typical) PTC resistance R versus PTC temperature T PTC (measured at low signal voltage) Please read Cautions and warnings and Important notes at the end of this document. PTC Page M1100 ...

Page 6

Sensors Motor protection, single sensors Characteristics (typical) PTC resistance R versus PTC temperature T PTC (measured at low signal voltage) Please read Cautions and warnings and Important notes at the end of this document. PTC Page M1100 ...

Page 7

Sensors Motor protection, single sensors Cautions and warnings General EPCOS thermistors are designed for specific applications and should not be used for purposes not identified in our specifications, application notes and data books unless otherwise agreed with EPCOS during the ...

Page 8

Sensors Motor protection, single sensors Mounting Electrode must not be scratched before/during/after the mounting process. Contacts and housing used for assembly with thermistor have to be clean before mounting. Es- pecially grease or oil must be removed. When PTC thermistors ...

Page 9

Sensors Motor protection, single sensors Symbols and terms A Area C Heat capacity th f Frequency I Current I Maximum current max I Rated current R I PTC current PTC I Residual currrent r I Residual currrent in oil (for ...

Page 10

Sensors Motor protection, single sensors t Settling time (for level sensors Rated temperature R T Sensing temperature sense T Operating temperature op T PTC temperature PTC t Response time R T Reference temperature ref T Temperature at minimum ...

Page 11

Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical ...