A16Z-5070 Omron, A16Z-5070 Datasheet - Page 7

• Manufacturer Part Number: A16Z-5070
• Description: Background Label
• Manufacturer: Omron
• Type: Emergency Stop Switchr

Specifications of A16Z-5070

• Accessory Type: Emergency Stop Name Plate
• Label Size: 45mm Dia
• Colour: Yellow Name Plate
• Legend: Blank
• Svhc: No SVHC (15-Dec-2010)
• Color: Yellow
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: A16 Series Switches
• For Use With/related Products: A16 Series Emergency Stop Switches
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: A16Z5070; Z1435

A165E
Precautions
Mounting
Always make sure that the power is turned OFF before mounting,
removing, or wiring the Switch, or performing maintenance. Other-
wise electric shock or fire may result.
Tighten the mounting nut to the torque of 0.29 to 0.49 N S m (3 to
5 kgf S cm).
Wiring
Select an appropriate cable size depending on applied voltage and
current. Solder properly according to the following conditions.
Improper soldering may generate abnormal heat and cause a fire.
Wait for one minute after soldering before exerting any external
force on the solder.
Use non-corrosive rosin liquid as flux.
Make sure that the electric cord is wired so that it does not touch the
Unit. If the electric cord will touch the Unit, then electric wires with a
heat resistance of 100 C min. must be used.
After wiring the Switch, maintain an appropriate insulation distance.
Operating Environment
The structure with the IP65 enclosure rating will not be affected by
direct water splashing onto the front side of the panel at any angle.
LED
No external resistors are required because the Switch has a built-in
LED current-limiting resistor.
Operating Torque
Operating torque of the Selector Switch and Emergency Stop
Switch should be no more than 0.49 N S m (5 kgf S cm).
Others
The oil-resistant IP65 uses NBR rubber and is resistant to general
cutting oil and cooling oil. Some particular oils cannot be used with
the oil-resistant IP65, however, so contact your OMRON represen-
tative for details.
If the panel is to be finished with coating, etc., make sure that the
panel meets the specified dimensions after coating.
24 VDC
Rated voltage
Correct Use
1. Manual Soldering: 30 W, within 5 s
2. Automatic Soldering: 240 C, within 3 s
1,600
Built-in limiting resistor
A165E
7