DHR 200 C10 LEM, DHR 200 C10 Datasheet - Page 3

• Manufacturer Part Number: DHR 200 C10
• Description: CURRENT TRANSDUCER, 200A, 0-10V O/P
• Manufacturer: LEM

Specifications of DHR 200 C10

• Current Measuring Range Ac: 200A
• Current Measuring Range Dc: 200A
• Operating Frequency Range: DC To 6kHz
• Supply Voltage Range Dc: 20V To 50V
• Sensor Output: Voltage
• Accuracy: 1%
• Response Time: 150ms
• Svhc: No SVHC (15-Dec-2010)
• Current Consumption: 30mA
• Rohs Compliant: Yes
• Accuracy %: 1%
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

LEM Components
Dimensions DHR-C10 (in mm. 1 mm = 0.0394 inch)
Connections
Wires up to 2 mm
Ip
Ip
24 VDC Power
(+)
(-)
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
(Controller, meter etc)
(-)
1(+) 2(none) 3(out) 4(GND)
6
Load
Output Connector
10k
DHR
(+)
2 2.2 8
90
7 0
6 0
7 8
Is
Is
+24VDC
+24VDC
OUT
OUT
GND
GND
6 .80
Mechanical characteristics
For panel mounting, replace M4 screws by new one (not supplied)
with appropriate length to panel´s thickness.
Safety
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
General tolerance
Primary aperture
Panel mounting
Distance between holes
7
2 5
±1 mm
4 holes
70.0 mm & 78 mm
(see above dimensions)
32.0 mm
4
4.6 mm
www.lem.com
050526/4
Page 3/3