SME312D BANNER ENGINEERING, SME312D Datasheet - Page 6

• Manufacturer Part Number: SME312D
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of SME312D

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Sensor Input: Optical
• Output Type: Transistor
• Sensing Range Max: 380mm
• Contact Current Max: 150mA
• Switch Terminals: Cable

MINI-BEAM

Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Rating
Output Protection Circuitry
Output Response Time
Repeatability
Adjustments
Indicators
Construction
Environmental Rating
Connections
Operating Conditions
Application Notes
Certifications
P/N 55214 rev. E
®
Expert
10 to 30V dc (10% maximum ripple) at less than 45 mA, exclusive of load
Protected against reverse polarity and transient voltages
Bipolar: One current sourcing (PNP) and one current sinking (NPN) open-collector transistor
150 mA maximum each output at 25° C, derated to 100 mA at 70° C (derate ≈1 mA per °C)
Off-state leakage current: less than 5µA @ 30V dc
ON-state saturation current: less than 1V @ 10 mA; less than 1.5V @ 150 mA
Protected against false pulse on power-up and continuous overload or short-circuit of outputs
Sensors will respond to either a “light” or a “dark” signal of 500 microseconds or longer duration, 1 kHz max.
NOTE: 1 second delay on power-up; outputs do not conduct during this time.
100 microseconds (all models)
Push-button TEACH mode sensitivity setting (see Static TEACH, page 5); remote TEACH mode input is provided
(gray wire, see page 4)
Two LEDs: Yellow and Bi-color Green/Red (see Figures 1 and 2)
Reinforced thermoplastic polyester housing, totally encapsulated, o-ring seal, acrylic lenses, and stainless steel
screws.
Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 6, 12, and 13; IEC IP67
PVC-jacketed 5-conductor 2 m (6.5') or 9 m (30') unterminated cable, or 5-pin Euro-style quick-disconnect (QD) fitting
are available. QD cables are ordered separately; see page 11.
Temperature: –20° to +70° C (–4° to +158° F)
Max. Relative Humidity: 90% at 50° C (non-condensing)
The first condition presented during TEACH mode becomes the output ON condition.
™
Series
Specifications
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: [phone]