HFBR-4506Z Avago Technologies US Inc., HFBR-4506Z Datasheet - Page 6

FIBER OPTIC CONN DUPLEX

HFBR-4506Z

Manufacturer Part Number
HFBR-4506Z
Description
FIBER OPTIC CONN DUPLEX
Manufacturer
Avago Technologies US Inc.
Series
HFBRr
Type
Duplexr
Datasheet

Specifications of HFBR-4506Z

Simplex/duplex
Duplex
Ferrule Material
Plastic
Body Material
Plastic
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Mounting Type
-
Color
-
Connector Type
-
Connector Style
-
Fastening Type
-
Mode
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
516-2073
516-2073-2
516-2073-2

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HFBR-4506Z
Manufacturer:
Broadcom Limited
Quantity:
6 022
Part Number:
HFBR-4506Z
Manufacturer:
AVAGO
Quantity:
1 400
Part Number:
HFBR-4506Z
0
Step 3
Any excess fiber protruding from the connector end may
be cut off; however, the trimmed fiber should extend at
least 1.5 mm (0.06 in) from the connector end.
Insert the connector fully into the polishing fixture with
the trimmed fiber protruding from the bottom of the
fixture. This plastic polishing fixture can be used to polish
two simplex connectors or simplex latching connectors
simultaneously, or one duplex connector.
Note: The four dots on the bottom of the polishing fixture
are wear indicators. Replace the polishing fixture when any
dot is no longer visible. Typically, the polishing fixture can
be used 10 times; 10 duplex connectors or 20 simplex con­
nectors, two at a time.
Place the 600 grit abrasive paper on a flat smooth surface,
pressing down on the connector, polish the fiber and the
connector using a figure eight pattern of strokes until
the connector is flush with the bottom of the polishing
fixture. Wipe the connector and fixture with a clean cloth
or tissue.
6
Step 4
Place the flush connector and polishing fixture on the dull
side of the 3 µm pink lapping film and continue to polish
the fiber and connector for approximately 25 strokes. The
fiber end should be flat, smooth and clean.
This cable is now ready for use.
Note: Use of the pink lapping film fine polishing step results in
approximately 2 dB improvement in coupling performance
of either a transmitter­receiver link or a bulkhead/splice over
a 600 grit polish alone. This fine polish is comparable to the
Avago factory polish. The fine polishing step may be omitted
where an extra 2 dB of optical power is not essential, as with
short link lengths. Proper polishing of the tip of the fiber/con­
nector face results in a tip diameter between 2.5 mm (0.098
in.) minimum and 3.2 mm (0.126 in.) maximum..
HFBR-4593Z Polishing Kit

Related parts for HFBR-4506Z