F3SN-A0907P25 Omron, F3SN-A0907P25 Datasheet - Page 29

• Manufacturer Part Number: F3SN-A0907P25
• Description: Safety Light Curtain
• Manufacturer: Omron
• Series: F3SN-Ar

Specifications of F3SN-A0907P25

• Beam Spacing: 15mm
• Control Output Type: PNP
• No. Of Beams: 59
• Protection Height: 907mm
• Sensing Range Max: 10m
• Supply Voltage Max: 24VDC
• Peak Reflow Compatible (260 C): No
• Light Curtain Type: Safety
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Detection Zone and Intrusion Path
Refer to “Precautions for All Safety Sensors” for the installation
conditions of Safety Light Curtains.
F3SH-A Multi-beam Safety Sensor
·
Install protective structures around the machine so that
you must pass through the detection zone of the F3SH-A
to reach a hazardous part of the machine.
If it is possible for an operator to get between the sensor’s
detection zone and the hazardous part of the machine,
design the system so that machinery cannot start up
automatically. Make sure that machinery cannot restart
while the operator is in the hazardous area. Position the
switch for restarting machinery in a location from which
the status of the hazardous area can be seen clearly. The
switch position location must be a place where the switch
cannot be operated from within the hazardous area.
Failure to do so may result in serious injury.
After setting the fixed blanking, check that the F3SN-A
detects a test rod at any position in the detection zone
through which a person can reach the hazardous part of
the machine. If any positions are found by check above,
install protective structures to prevent intrusion, which the
F3SN-A can not detect.
Failure to do so may result in serious injury.
Use of the Fixed Blanking Function (F3SN-A only)
http://www.ia.omron.com/
!WARNING
Safety Distance
Always maintain a safe distance (S) between the light
curtain and a hazardous part of a machine.
Failure to do so causes the machine to fail to stop before
an operator reaches the dangerous area and may result
in serious injury.
Use of the floating blanking increases the size of the
detection capability. To calculate a safety distance, be
sure to use the increased size of the detection capability.
Failure to do so causes the machine to fail to stop before
an operator reaches the dangerous area and may result
in serious injury.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
F3SN-A/F3SN-B/F3SH-A
29