D2VW-01L2A-1HS Omron, D2VW-01L2A-1HS Datasheet - Page 9

• Manufacturer Part Number: D2VW-01L2A-1HS
• Description: MINIATURE BASIC SWITCH
• Manufacturer: Omron
• Series: D2VWr
• Type: Basicr

Specifications of D2VW-01L2A-1HS

• Circuit: SPDT
• Switch Function: On-Mom
• Contact Rating @ Voltage: 0.1A @ 125VAC
• Actuator Type: Lever, Roller
• Mounting Type: Chassis Mount
• Termination Style: Solder, Quick Connect - .187" (4.7mm)
• Operating Force: 230gf
• Contact Form: SPDT
• Contact Rating: 0.1 Amp at 125 Volts, 0.1 Amp at 30 Volts
• Actuator: Hinge Roller Lever
• Body Style: Miniature
• Current, Rating: 0.1 A
• Dielectric Strength: 1500 VAC
• Ip Rating: IP50
• Mounting Hole Size: 3.1 mm
• Number Of Poles: 1
• Operation: Snap Action
• Special Features: Short Hinge Lever
• Standards: IEC Approved
• Temperature Rating: -40 to +90 °C
• Termination: Solder/Quick Connect
• Voltage, Rating: 125/30 VAC/VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: D2VW-01L2A-1HS; D2VW01L2A1HS; SW864

Precautions
■ Mounting
Use two M3 mounting screws with spring washers to mount the
switch. Tighten the screws to a torque of 0.39 to 0.59 N • m (4 to 6
kgf • cm).
Mounting holes
■ Operations
Make sure that the switching object is perfectly separated from the
actuator when the switch is not operated and the actuator is pressed
appropriately by the switching object when the switch is operated.
The switch should be set so that its stroke will be within the rated OT
when the switch is operated.
Install the switching object so that its moving direction is the same as
that of the actuator.
6
■ Hinge roller lever
D2VW-01L2-1MS
D2VW-5L2-1MS
Snap Action Switch
D2VW
■ Enclosure Ratings
The D2VW was tested under water and passed the following water-
tightness test, which however, does not mean that the D2VW can be
used in the water.
JIS C0929 (rules for testing the watertightness of electrical devices
and materials), class 7 (watertightness test). Refer to the following
illustration for the test method at OMRON.
Note: The object to be tested is left in the water for 30 minutes on con-
dition that the distance between the surface of the water and
the top of the object be 15 cm minimum and the distance be-
tween the surface of the water and the bottom of the object be
1 m minimum.