MINI-PS-100-240AC/10-15DC/2 Phoenix Contact, MINI-PS-100-240AC/10-15DC/2 Datasheet - Page 7

• Manufacturer Part Number: MINI-PS-100-240AC/10-15DC/2
• Description: POWER SUPPLY PRIMARY SWITCH MODE
• Manufacturer: Phoenix Contact

Specifications of MINI-PS-100-240AC/10-15DC/2

• Power Supply Type: Switch Mode
• Power Supply Output Type: Fixed
• No. Of Output Channels: 1
• Output Voltage: 12VDC
• Output Current: 2A
• Input Voltage: 85V To 265V
• Supply Voltage Typ: 110VAC / 230VAC
• No. Of Outputs: 1
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Power Supply, Primary Switch Mode, Narrow Design – MINI-PS-100-240AC/10-15DC/2
6.4. Output (
and "–" screw connections on the screw connection
Protecting the Secondary Side:
proof. In the event of an error, the output voltage is
limited to a maximum of 20 V DC.
correct size for the maximum output current or have
separate fuse protection.
sections to keep voltage drops on the cables to a
minimum.
DC OK LED
evaluation in the control cabinet.
LED ON
LED OFF a) The output voltage is ≤ 0.9 x U
7. Function
7.1. Output Characteristic Curve (Figure 10).
2 A up to an ambient temperature of 60°C (140°F).
With an ambient temperature of up to 40°C (104°F) the
device continuously supplies an output current of 2.3 A.
At temperatures up to 60°C (140°F), the POWER
BOOST provides a short-term output current of 2.3 A
for a few minutes.
U/I characteristic curve shown in Figure 10.
current I
output voltage.
the entire set secondary voltage is available again.
capacitive loads and devices with DC/DC converters
can be supplied by MINI POWER in the input circuit
without any problems.
in your system configuration is ensured at all times.
The 10 - 15 V DC connection is made using the "+"
The device is electronic short-circuit-proof and idling-
It should be ensured that all output cables are the
The secondary side cables should have large cross
The green DC OK LED enables local function
The device can supply a nominal output current of
With high loads, the working point demonstrates the
On an overload or short circuit, the entire output
Once the overload or short circuit has been removed,
The U/I characteristic curve ensures that both heavy
Connected fuses are reliably tripped. The selectivity
BOOST
b) No mains voltage is present or there is a device fault.
Normal operation of the power supply
There is a secondary load short circuit or overload
outside the POWER BOOST area.
2 2 2 2
, Figure 9)
is provided permanently at a reduced
N
.
PHOENIX CONTACT page 7 of 8
2 2 2 2
.
10 - 15 V
U
U
[ V ]
OUT
N
< 60°C
(140°F)
I
N
2
U
< 40°C
(104°F)
OUT
I
BOOST
= 10 - 15 V
2.3
I
Figure 10
OUT
[ A ]