AD586JR Analog Devices Inc, AD586JR Datasheet - Page 8

• Manufacturer Part Number: AD586JR
• Description: Voltage Reference Temperature Coefficient:25 Ppm/ C
• Manufacturer: Analog Devices Inc

Specifications of AD586JR

• Package/case: 8-SOIC
• Leaded Process Compatible: No
• Mounting Type: Surface Mount
• Peak Reflow Compatible (260 C): No
• Controller Series: 586
• Number Of Pins: 8
• Output Voltage: 5V
• Rohs Status: RoHS non-compliant
• Reference Type: Series
• Voltage - Output: 5V
• Tolerance: ±20mV
• Temperature Coefficient: 25ppm/°C
• Voltage - Input: 10.8 ~ 36 V
• Number Of Channels: 1
• Current - Quiescent: 3.0mA
• Current - Output: 10mA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Current - Cathode: -
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

AD586
TURN-ON TIME
Upon application of power (cold start), the time required for
the output voltage to reach its final value within a specified
error band is defined as the turn-on settling time. Two compo-
nents normally associated with this are the time for the active
circuits to settle, and the time for the thermal gradients on the
chip to stabilize. Figure 9, Figure 10, and Figure 11 show the
turn-on characteristics of the AD586. It shows the settling to be
about 60 µs to 0.01%. Note the absence of any thermal tails
when the horizontal scale is expanded to l ms/cm in Figure 10.
Output turn-on time is modified when an external noise reduc-
tion capacitor is used. When present, this capacitor acts as an
additional load to the current source of the internal Zener
diode, resulting in a somewhat longer turn-on time. In the case
of a 1 µF capacitor, the initial turn-on time is approximately
400 ms to 0.01% (see Figure 11).
C
Figure 8. Effect of 1 µF Noise Reduction Capacitor on Broadband Noise
N
V
NO C
OUT
V
= 1µF
IN
N
10V
200µV
Figure 9. Electrical Turn-On
1mV
50µS
20µS
Rev. G | Page 8 of 16
DYNAMIC PERFORMANCE
The output buffer amplifier is designed to provide the AD586
with static and dynamic load regulation superior to less com-
plete references.
Many ADCs and DACs present transient current loads to the
reference, and poor reference response can degrade the per-
formance of the converter.
Figure 12, Figure 13, and Figure 14 display the characteristics of
the AD586 output amplifier driving a 0 mA to 10 mA load.
V
V
OUT
OUT
V
V
IN
IN
3.5V
Figure 11. Turn-On with 1µF C
10V
10V
Figure 12. Transient Load Test Circuit
Figure 10. Extended Time Scale
1mV
5V
AD586
N
V
Characteristics
L
500Ω
5V
0V
1mS
100mS
V
OUT