110155 MARL, 110155 Datasheet - Page 5

• Manufacturer Part Number: 110155
• Description: LED, 5MM, WHITE, 980MCD
• Manufacturer: MARL

Specifications of 110155

• Bulb Size: T-1 3/4 (5mm)
• Led Color: White
• Luminous Intensity: 420mcd
• Viewing Angle: 70°
• Forward Current If: 30mA
• Forward Voltage: 3.6V
• Led Mounting: Through Hole
• Lens Shape: Round
• Forward Current If Max: 30mA
• Color: White
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7.CAUTIONS
(1) Lead Forming
(2) Storage
(3) Static Electricity
The LEDs are devices which are materialized by combining Blue LEDs and special phosphors.
Consequently, the color of the LEDs is changed a little by an operating current.
Care should be taken after due consideration when using LEDs.
· When forming leads, the leads should be bent at a point at least 3mm from the base of the epoxy bulb.
· Lead forming should be done before soldering.
· Do not apply any bending stress to the base of the lead. The stress to the base may damage the LED’s
· When mounting the LEDs onto a printed circuit board, the holes on the circuit board should be exactly
· The LEDs should be stored at 30°C or less and 70%RH or less after being shipped from Nichia and
· Nichia LED leadframes are comprised of a silver plated copper alloy. The silver surface may be
· Please avoid rapid transitions in ambient temperature, especially, in high humidity environments where
· Static electricity or surge voltage damages the LEDs.
· All devices, equipment and machinery must be properly grounded. It is recommended that measures
· When inspecting the final products in which LEDs were assembled, it is recommended to check
· Damaged LEDs will show some unusual characteristics such as the leak current remarkably
Do not use the base of the leadframe as a fulcrum during lead forming.
characteristics or it may break the LEDs.
aligned with the leads of the LEDs. If the LEDs are mounted with stress at the leads, it causes
deterioration of the epoxy resin and this will degrade the LEDs.
the storage life limits are 3 months.
for a year in a sealed container with a nitrogen atmosphere and moisture absorbent material.
affected by environments which contain corrosive gases and so on. Please avoid conditions which
may cause the LED to corrode, tarnish or discolor. This corrosion or discoloration may cause difficulty
during soldering operations. It is recommended that the LEDs be used as soon as possible.
condensation can occur.
It is recommended that a wrist band or an anti-electrostatic glove be used when handling the LEDs.
be taken against surge voltage to the equipment that mounts the LEDs.
whether the assembled LEDs are damaged by static electricity or not.
static-damaged LEDs by a light-on test or a VF test at a lower current (below 1mA is recommended).
increases, the forward voltage becomes lower, or the LEDs do not light at the low current.
Criteria : (V
F
> 2.0V at I
F
=0.5mA)
If the LEDs are stored for 3 months or more, they can be stored
-4-
It is easy to find
Nichia STSE-CW2165B
<Cat.No.031210>