CSBLA500KJ58-B0 Murata, CSBLA500KJ58-B0 Datasheet - Page 39

• Manufacturer Part Number: CSBLA500KJ58-B0
• Description: RESONATOR, 0.50MHZ RESONATOR, 0.50MHZ
• Manufacturer: Murata

Specifications of CSBLA500KJ58-B0

• Frequency, Resonant: 0.5MHZ
• Capacitor Dielectric Type: CERAMIC RESONATOR
• Tolerance,: 0.5%
• Tolerance, -: 0.5%
• Pitch, Lead: 5MM
• Case Style: RADIAL
• Depth, External: 3.3MM
• Length / Height,: ROHS COMPLIANT

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Soldering Conditions
(1) Reflow
(2) Soldering Iron
2. Wash
3. Notice for Mounting
CSACW/CSTCW/CSTCZ Series
One heat stress, shown in the profile at right, is applied to
resonator; then, after being placed in natural conditions
for 1 hour, the resonator is measured.
(a) Pre-heating conditions should be +150 to +180 C for
(b) Heating conditions should be within 40 seconds at
Components shall be measured after soldering on PCB
at +350 5 C for 3.0 0.5 seconds and leaving in natural
condition for 24 hours. The soldering iron shall not touch
the components while soldering.
Please contact us in case you need washable component.
(a) Please insure the component is thoroughly evaluated
(b) Please do not apply excess mechanical stress to the
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
60 to 120 seconds. Ascending time up to +150 C
should be longer than 30 seconds.
+230 C min., but peak temperature should be Iower
than +260 C.
in your application circuit.
component and terminals during soldering.
MHz Chip Type Notice (Soldering and Mounting) for General Usage
230
180
150
30 sec.
min.
(150-180˚C)
Pre-heating
60-120 sec.
(260˚C max.)
Heating
(230˚C)
40 sec.
Peak
max.
Gradual
Cooling
120 sec.
min.
37
P16E.pdf
08.3.3
7