IP20 SOLA HEVI DUTY, IP20 Datasheet - Page 20

• Manufacturer Part Number: IP20
• Description: Fuse Cover Kit
• Manufacturer: SOLA HEVI DUTY

Specifications of IP20

• Peak Reflow Compatible (260 C): No
• Kit Contents: 2 Covers And Thread Forming Screws
• Leaded Process Compatible: No
• For Use With: SBE Fuse Block
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.2
Spacers added to support
base to accommodate
additional battery cabinets
External Battery Cabinet Installation
Optional Sola/Hevi-Duty external battery cabinets may be connected to the UPS to provide additional
battery run time. External battery cabinets are designed to be placed on one side of the UPS or
stacked beneath the UPS.
1. Visually inspect the external battery cabinet for freight damage. Report damage to the carrier
2. For slide rail installations, first remove the top/side fin. Top/side fin slides forward and then lift
3. Securing hardware and slide rails are sold separately. Please contact your local dealer or Sola/
4. Use the enclosed support bases for the tower option to prevent tip-over. One additional set of
5. Connect the supplied external battery cabinet cable to the rear of the external battery cabinet,
6. The UPS is now equipped with additional backup battery run time. For approximate battery run
!
!
and your local dealer or Sola/Hevi-Duty representative.
up to remove. Optional rack-mount handles are shipped with the external battery cabinet and
may be installed at this time if desired.
Hevi-Duty representative for these additional options and any assistance needed. Fasten the
slides into position with the screws per the instructions included with the slide rails.
support base extensions ships with each external battery cabinet.
then to the rear of the UPS.
times, refer to Table 6.
3U
CAUTION
The external battery cabinet(s) are heavy (see 13.0 - Specifications (Sechnische Daten)).
External battery cabinets can be used in rack-mount or tower configuration. Take proper
precautions when lifting them.
VORSICHT
Externe Batteriegehäuse sind schwer (siehe 13.0 - Specifications (Sechnische Daten)).
Externe Batteriegehäuse können in einer Rack-Montage- oder Turmkonfiguration eingesetzt
werden. Ergreifen Sie die entsprechenden Vorsichtsmaßnahmen, wenn sie gehoben werden
müssen.
NOTE
You must use the included configuration program to program the UPS for the number
of external battery cabinets connected. Instructions for the configuration program are in
7.0 - Configuration Program.
2U
2U
14
Installation and Configuration