XP1001001-03R Lantronix, XP1001001-03R Datasheet - Page 3

• Manufacturer Part Number: XP1001001-03R
• Description: SERIAL TO ETHERNET MODULE, 0-70DEGC
• Manufacturer: Lantronix

Specifications of XP1001001-03R

• Development Tool Type: Embedded Ethernet Device Server
• Tool / Board Application: Embedded Design
• Applications: Web Based Application
• Data Rate: 921.6Kbps
• Interface Type: Serial
• Processor: RoHS Compliant
• Module Interface: Serial
• Rohs Compliant: Yes

16.05
[0.632]
.XX+/-0.05[0.002]
TOLERANCE
12.30
[0.484]
The XPort uses Internet Protocol (IP) for network
communications and Transmission Control
Protocol (TCP) to assure that no data is lost or
duplicated, and that everything sent arrives
correctly at the target.
Other supported protocols are listed below:
•
•
•
•
•
* For a complete discussion of protocol support,
see the XPort user manual.
The device contains two bi-color LEDs built into the
front of the XPort connector. (See dimension
drawing for location.)
The hole pattern and mounting dimensions for the
XPort are shown in the following drawing:
XPort Data Sheet 910-815F May 2010
For proper heat dissipation, the PCB should
have approximately 1 square inch of copper
attached to the shield tabs. The shield tabs are
an important source of heat sinking for the
device.
Link LED (Left Side) Activity LED (Right Side)
Color
Off
Amber
Green
O 3.25 [ 0.128]
Protocol Support
LEDs
Recommended PC Board Layout
FRONT
ARP, UDP, TCP, ICMP, Telnet, TFTP, AutoIP,
DHCP, HTTP, and SNMP for network
communications.
TCP, UDP, and Telnet for connections to the serial
port.
TFTP for firmware updates.
IP for addressing, routing, and data block handling
over the network.
User Datagram Protocol (UDP) for typical datagram
applications in which devices interact with other
devices without maintaining a point-to-point
connection.
10.84 [0.427]
O
DIMS = mm (in)
Meaning Color
No Link
10 Mbps
100 Mbps
O 0.90 [ 0.035]
11.90 [0.468]
8
2
O
7
1
Off
Amber
Green
6.35 [0.250]
O
SHIELD TAB
2.54 [0.100]
1.60[ 0.063]
1.27 [0.050]
Meaning
No Activity
Half-Duplex
Full-Duplex
2.54 [0.100]
3.58 [0.141]
The XPort dimensions are shown in the following
drawings:
Note: PADS and PROTEL design files are included
with the XPort development kit.
Dimensions
Bottom View
Side View
Page 3 of 6